Subscribe to Our Youtube Channel
Summary of Contents for Posch M7200
- Page 1 Operating Instructions Bundling device D1010349 - V001 *D1010349-V001* English Copyright by Posch Gesellschaft m.b.H., Made in Austria...
- Page 2 Machine number:................Serial number:..................POSCH Austria: 8430 Leibnitz, Paul-Anton-Keller-Strasse 40, telephone: +43 (0) 3452/82954, fax: +43 (0) 3452/82954-53, e-mail: leibnitz@posch.com POSCH Germany: 84149 Velden/Vils, Preysingallee 19, telephone: +49 (0) 8742/2081, fax: +49 (0) 8742/2083, e-mail: velden@posch.com...
-
Page 3: Table Of Contents
Contents Contents Foreword Copyright notice Liability for defects Reservations Definitions Operating instructions Safety information Explanation of symbols General safety information Safety instructions for bundling device Remaining risks Proper use Incorrect use General Scope Description The most important components of the machine Stickers and their meaning Operation Work operation... - Page 4 Contents Service EC Declaration of Conformity...
-
Page 5: Foreword
Foreword Foreword Thank you for buying our product. This machine has been built in conformity with applicable European standards and regulations. These operating instructions explain how to operate the machine safely and efficiently and how to maintain it. Any person entrusted with the transport, installation, commissioning, operation or maintenance of the machine must have read and understood: ▪... -
Page 6: Operating Instructions
Foreword The operating personnel (operators) are those entrusted by the operator to operate the machine. Technical personnel Technical personnel are persons entrusted by the operator of the machine with special tasks such as installation, set-up, maintenance and troubleshooting. Electrician An electrician is a person who, by virtue of his specialist training, has knowledge of electrical systems, standards and regulations and is able to identify and prevent possible hazards. -
Page 7: Safety Information
Safety information Safety information Explanation of symbols The following symbols and instructions in this manual provide warnings about possible personal injury or property damage or give useful information about working with the machine. DANGER Warning about danger zones Instruction regarding safe working, where non-compliance entails the risk of serious or fatal injury. -
Page 8: Safety Instructions For Bundling Device
Only carry out repair, setup, maintenance and cleaning work when the drive is switched off and the tool is stationary. Only use original - POSCH - spare parts. Do not modify or tamper with the machine. Safety instructions for bundling device Never stand in front of the filled cradle, always stand to the side. -
Page 9: General
Scope This user manual applies to the following machines: Machine type Article no. * Designation - Type Drive M7200 Bundling device - Standard M7205 Bundling device - Comfort *The article number is stamped on the machine's rating plate. Models Additional equipment... -
Page 10: The Most Important Components Of The Machine
General The most important components of the machine End panel Cradle Locking lever Rope winch Lock-release cord Cord reel Three-point linkage Tensioning cord Identification plate Winding tube Frame Diagram, top: Bundling device Diagram, bottom: Comfort bundling device... -
Page 11: Stickers And Their Meaning
General Stickers and their meaning Always read the user manual before operating the machine Z204 0010 Stickers on controls... -
Page 12: Operation
Operation Operation Work operation Only one person may operate the machine at a time. Ensure that no other people are in the vicinity of the machine. 4.1.1 Bundling device 4.1.1.1 Put the wood in 1. Attach the bundling device to the three-point linkage of the tractor. 2. - Page 13 Operation – The lock-release cord can also be operated from the tractor. 2. To prepare the bundling device so it can be filled again, lower the device using the tractor's hydraulic system and drive the tractor forwards a short distance. The cradle latches in place again automatically and can be refilled.
- Page 14 Operation 1. Lay the tensioning cord from the rope winch over the top of the firewood and clip it into the ring. 2. Use the rope winch to squeeze the firewood together tightly. 3. Pull the binding cord out of the cord reel from below and push it through the winding tube from the side you are holding.
- Page 15 Operation 4.1.3 Switching the wood stop to the other side The wood stop can also be mounted on the opposite side. The device is already prepared for this; the parts of the wood stop simply need to be undone and then mounted on the other side.
-
Page 16: Transport
Transport Transport Transporting by three-point linkage on the tractor ▪ Attach the machine to the three-point linkage and use the tractor hydraulics to raise it. If the tractor's rear lights are obscured, a light must be fitted to the rear of the machine (e.g. magnetic holder, clip-on light, etc.) Due to the weight of the machine, the tractor-machine combination can become unstable. -
Page 17: Comfort Bundling Device
Transport Comfort bundling device Detent lever Wood stop Winding tube 1. Fold the wood stop up completely and make sure that the detent lever is engaged. 2. Insert the two winding tubes into the holder. -
Page 18: Checks
Checks Checks Screw fittings Tighten all screws and nuts after the first hour of operation. Tighten the screws and nuts after every 100 hours of operation. ▪ Replace missing screws and nuts. Rope winch The rope must always be wound as shown on the left-hand side of the illustration. After the cord has been unwound from the drum, there must always be at least 3 revolutions of cord remaining. -
Page 19: Maintenance
Maintenance Maintenance Never work without the protective guards in place. Only use original - POSCH - spare parts. Lubrication Dispose of oily and greasy parts and oil residues in accordance with legal regulations. 7.1.1 Lubricating diagram A small amount of grease should be applied to the swivel point from time to time. -
Page 20: Troubleshooting
Troubleshooting Troubleshooting Fault Possible cause Remedy Latch does not engage No grease on latch Grease latch around area where it engages... -
Page 21: Technical Data
Technical data Technical data Type Standard Comfort Transport Transport method Three-point linkage cat1/cat2 Dimensions * Length Width Height Weight *..The stated dimensions and weights are for guidance purposes and apply to the basic equipment. - Page 22 Service Service POSCH- Product To order spare parts for your machine please contact your local dealer directly. If you require a replacement parts list for your machine, you can download this at any time by entering the serial number at the following link:...
- Page 23 This Declaration is not valid for any modifications to the machine which are not approved by us. Firewood packing - Bundling device Item no.: M7200 , M7205 Serial no.: from 1,001,001A To implement the health and safety requirements mentioned in the EC Directives, the following standards are applied: ▪...
- Page 24 Your Posch-Dealer...
Need help?
Do you have a question about the M7200 and is the answer not in the manual?
Questions and answers