LOGOJET UV R Series Quick Start Manual

7-15 days:
These steps should be followed only if the printer will be back in production in less than 15 days:
1. Move the carriage to the center of the print area.
2. Avoiding spill ink, gently unplug the ink bags from the needles.
3. Storage the ink bags in the proper environmental conditions.
4. Run at least six head cleans commands, to remove the remaining ink in the system.
5. Move the carriage to the center of the print area.
6. Remove ink lines and dampers. Ink lines must be flushed with alcohol until there it runs clear inside of them without
getting mixed with any color.
7. Using a clean syringe, push two syringes full of air per channel.
8. Using a clean syringe, push/flush at least two syringes full of alcohol in each print head channels.
9. Confirm all nozzles are open, a straight curtain must be seen coming out under every print head channel.
10. If you don't get a good nozzle condition, repeat the air and alcohol flushing.
11. Finalize with two more syringes of air to clean the print head channels and remove the alcohol of the system.
12. Install jumpers in the print head tubing.
13. Clean wiper blade and cap tops with alcohol and removing any remaining ink.
14. Execute capping command to move the head over capping station.
15. Close the RCC program in the computer.
16. Turn off the printer.
17. If printer will be moved, install the brackets for the capping station and carriage.
Taking the printer out of storage after no more than 15 days:
These steps should be followed only if the printer has been in storage up to fifteen days:
1. Remove carriage and capping station brackets, if they were installed.
2. Turn on the printer.
3. Open the RCC program in computer. USB cable must be connected between printer and computer.
4. Move the carriage to the center of the print area.
5. Remove jumpers, they could be flushed with alcohol to prepare them for a second use.
6. Install clean/new ink lines with new dampers.
7. Agitate all the ink bags, check the manufacture day of each bag, all inks have a life span of one year after the MFG
date.
8. Place the bags in the ink tray and plug them to the needles.
9. Run at least three head cleans to prime the ink inside the system.
10. Run the nozzle test to confirm all nozzles are recovered.
11. More head clean commands might be needed to recover the printer to a 100% nozzle state.
PREPARING A PRINTER FOR SHORT TERM STORAGE
LOGOJET UV R-SERIES