Andrews Dehumidification FD40 2 Series Operating Instructions & Safety Manual

FD40 Series 2
Dehumidi er
Operating Instructions
& Safety Guide
0800 211 611
andrews-sykes.com
General Safety
Dehumidi ers are for internal use only.
This equipment should only be used by a competent
person who has read and understood these instructions.
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately.
Never operate this equipment if you are ill, feeling tired or
under the in uence of alcohol or drugs.
Keep all vents and grills clear of obstructions.
Keep children and animals away from the dehumidifer.
Never leave them alone in a room where the units are in
use.
Make sure equipment is switched o and unplugged after
use.
Electrical Safety
This unit is dual voltage and can be used via a standard domestic
13 amp 230 volt socket or 110 volt power supply.
THE FD40 SERIES 2 HAS AN AUTOMATIC CHANGEOVER
TRANSFORMER NO NEED TO SELECT THE REQUIRED VOLTAGE
Always inspect plugs and power cables for damage before
plugging into power supply.
DO NOT USE IF ANY DAMAGE IS FOUND.
Ensure cables are installed to prevent hazards.
I f an extension lead is used, ensure it is of the correct standard
and fully uncoiled before use.
Cables must not be laid in wet or damp areas.
Do not move equipment while operating.
Do not pull equipment by the power lead.
It is recommended that the electrical supply to this equipment is
protected by an RCD.
Getting started and operation
Fig 1
Position equipment on level
ground, position centrally in the
area allowing fr ee air flow.
Fit correct plug top to power input
lead to suit operating voltage
selected.
13 amp BS1363 230volt or 16 amp
BS4343 Blue plug
16 amp BS4343 110 volt Yellow
plug.
No requirement to select voltage as
the unit has an automatic
changeover transformer.
110 V
230 V