OMNIKEY CardMan 5121 Install Manual

RFID Smart Card Reader Technology
CardMan
®
This guide describes the required steps to use a
CardMan 5121 with Windows 98, ME, 2000 or XP.
1. The latest drivers can be found on the enclosed driver CD.
2. Make sure you have a
free USB port on either
your PC or connected
USB hub.
3. Connect the reader to
the PC.
4. Windows XP might already have a default Microsoft CCID (Chip
Card Interface Device) driver installed and just indicate that the
new hardware can be used now, like shown in step 15.
The standard CCID driver must be updated manually with a
driver that supports the extended features of the CardMan
5121. (Continue with Step 5.)
For systems without the default CCID drivers and Windows 98,
ME or 2000, the "Found New Hardware Wizard" will pop up.
(Continue with Step 8.)
5. Open the Control
Panel and double-click
the system icon, then
select the
"Hardware" tab-sheet
and click
"Device Manager".
6. In the Device Manager, expand "Smart card readers" and
double-click "USB Smart Card reader"
CardMan ® 5121 Install Guide - May 2004
5121 Install Guide
To receive further information, please contact
E-Mail: support@omnikey.com
Subject to change without notice
7. Select the
"Driver" tab and
click
"Update Driver".
8. Select "Install
from list or
specific
location" and
click "Next".
9. Select "Don't
search. I will
choose the
driver to
install" and
click "Next".
10. Click on
"Have Disk".
OMNIKEY
or visit our homepage www.omnikey.com
Page 1/2
Copyright © 2004 by OMNIKEY