Advertisement
Copy stand with aluminium profiles
Parts and tools:
2x corner bracket with screws and t-nuts
3x steel connector 90° with screws and t-nuts
2x connecting plate with screws and t-nuts
2x corner bracket cover
6x end cover
3x aluminium profile 30cm
1x aluminium profile 80cm
The Camera, LED backlight, powerbank
and negative holder you can see in this
picture are not part of the kit.
2x spring loaded slot nut M5
2x countersink allen screw M5x16
Buy seperately:
Tripod clamp Andoer DM-55
4x felt pads for furniture
3mm allen wrench
4mm allen wrench
Advertisement
Table of Contents
Summary of Contents for DOLD Reprostativ V5
- Page 1 Copy stand with aluminium profiles The Camera, LED backlight, powerbank and negative holder you can see in this picture are not part of the kit. Parts and tools: 2x spring loaded slot nut M5 2x corner bracket with screws and t-nuts 2x countersink allen screw M5x16 3x steel connector 90°...
- Page 2 First attatch screws and t-nuts to a corner bracket. Screw in the screw for about one rotation into the t-nut. Align the t-nut to the slot so you can insert the corner bracket with its nut. As you tighten the screw the t-nut rotates by 90°...
- Page 3 Place the 80cm profile in the center of the 30cm profile like shown in the picture. Connect the profiles with the 90° steel connectors. Align it exactly square and tighten the screws Insert both of the M5 spring loaded slot nuts into the slot or slide them in from one end.
- Page 4 Attach covers to the corner brackets. Attach end covers to the ends. Attach self-adhesive felt pads to the bottom corners. 3 – 2 – 1 ….. Happy Shooting...
Need help?
Do you have a question about the Reprostativ V5 and is the answer not in the manual?
Questions and answers