molex 19078-0307 Instruction Sheet

Bench Adapter Assembly for Air-Powered Crimp Tool

Features

Higher volume output with less operator fatigue
Operates on standard shop air (85-95 PSI)
Perfect for assembly line operations.

SCOPE

This bench adapter assembly 19078-0307 with foot switch is intended for use with the 19279-0001 (AT-200 Air-
Powered Crimping Tool) and/ or with Electrical Control Box (Order No. 64001-4000).

OPERATION

When using the bench adapter assembly, be sure the base is securely fastened to a clean, sturdy workbench
or table in a well-lighted area. Fasten the stand with (3) #1/4-20 FHCS, nuts, and washers not supplied of
sufficient length for the work bench.
CONNECT TUBING FROM
FOOT SWITCH WITHOUT FITTING
BENCH ADAPTER
When using the bench adapter assembly remove the air hose (Order No. 19279-0140) from the crimp tool and
connect the tubing from the footswitch. See Figure 1. If using the Optional Electrical Controls Order No. 64001-
4000 see the Instruction Manual ATS-192790001 for additional information.
Doc No: ATS-19078-0307
Revision: B
Bench Adapter Assembly
For Air-Powered Crimp Tool
Instruction Sheet
Order No. 19078-0307
CONNECT TUBING FROM
FOOT SWITCH WITH FITTING
FOOT SWITCH
Figure 1
Release Date: 05-27-09
Revision Date: 05-27-09
FILTER REGULATOR
SECURE AIR CRIMPING
TOOL IN POSTION
UNCONTROLLED COPY
(NOT SUPPLIED)
TO AIR
SUPPLY
(NOT SUPPLIED)
Page 1 of 2