Panasonic ER-GC52 Operating Instructions Manual page 16

3. Brush any hair trimmings out
from between the stationary
blade and the moving blade
while pressing down the
cleaning lever ( a ) to raise the
moving blade.
4. Apply the oil to the blade. (See this page.)
5. Attach the blade and attachment to the main body.
Removing and mounting the blade
Removing the blade
Hold the clipper with the switch
facing upward and push the blade
with your thumb while catching the
blade in your other hand.
16
PB019062 - ER-GC52 _(01GB)_04-23-20.indd 16
a Mounting the blade
Fit the mounting hook (
on the clipper and then push in until you hear a click.
A
Lubrication
• Apply the oil to the clipper before and after each use.
• Make sure that the clipper is turned off.
1
Remove the blade.
2
Apply a drop of the oil to
each indicated point.
3
Attach the blade to the
main body, turn on the
power and allow to run for
approximately 5 seconds.
) into the blade mounting (
B
B
)
A
2020/4/23 13:16:19