Pembina Centaur Rabbit 3 Manual

LOCATION:
All Locations
HAZARDS PRESENT
•
Slip and fall
•
Corrosive chemicals
•
MSI- Back injury
•
Electric shock
•
Surfaces causing falls – wet
floors
•
Vibration
•
Noise ~70-80 dBA
PRE-JOB STEPS:
o Check equipment for any obvious defects or damage. Do not use a damaged machine and notify your
supervisor.
o Complete the pre-run inspection prior to operating the equipment:
o Do not pull the machine by the plug or cord.
o Do not handle plugs with wet hands.
o Never activate the power when the handle is in the upright position.
o Do not release handle grips until the pad comes to a complete stop.
o Wear non-slip, steel toe safety boots.
o Ensure the floor to be washed has been swept. Sweeping the floor properly will help prevent streaking
as well as prolong the life of the auto-scrubber. Place out caution signs and barricades required in
work area(s)
o Get help to move large or heavy objects or furniture. Remember to try to keep your back straight and
use your weight to help slide objects rather than using only your arms. If lifting, bend and push
through your legs. Communicate the timing for the lift if lifting with another worker
PROCEDURE:
1. Remove loose objects from the floor area where you are working to prevent injury and damage.
2. Place "wet floor" signs as needed and restrict access to others to prevent injury.
3. Install the appropriate pad driver. Always make sure your pad driver is properly secured to the
SAFE WORK PROCEDURE
WRITTEN BY: APPROVED BY:
Lorie Carriere Albert Jubinville
PERSONAL PROTECTIVE
•
disposable gloves
•
Non-slip footwear
•
Hearing protection
•
"Wet Floor" sign
•
Safety Glasses
SAFE WORK PROCEDURE
Centaur Rabbit 3
Floor Machine
Page 1 of 4
DATE: LAST REVISION:
January 30, 2023
ADDITIONAL
REQUIREMENTS
•
Lift/material handling
training
•
WHMIS training
new