Advertisement
Quick Links
Advertisement
Summary of Contents for cabinaid Pro
- Page 1 Installation manual Cabinaid Pro...
-
Page 2: Parts List
In addition, it is best to hang the Cabinaid AED cabinet out of direct sunlight and weather influences when possible. Although the AED cabinet is climate proof, it is the best way to... - Page 3 Step 2: Remove the climate control unit from the bottom of the Cabinaid Pro and put it aside for now. The climate control unit is not fastened or connected yet.
- Page 4 Once installed and mounted to the wall. The Cabinaid Pro cup should look like the image on the right. Step 7: Take out the rubber tule delivered with the Cabinaid and put the cable through. The end result should look like the image on the right.
- Page 5 Installation of the climate control unit After mounting your Cabinaid Pro cabinet to the wall and running the power lead into the main compartment. You can follow the following steps the instal the climate control unit. WARNING: The power supply should not be connected to the power at this stage! The connections should be made close to the Cabinaid AED cabinet on the wall as the cables don’t have many spare length.
- Page 6 Step 2: Connect the cables to the circuit board: Firstly attach the blue marked cable to the blue highlighted position as seen on the image below. Secondly attach the white cable to the white highlited position as seen on the left image. The white cable is connected to the connecter the most on the back of the board.
- Page 7 If you have attached everything correctly the connections should look like the image on the right side. Step 2: Check that the power lead is no longer then +/- 10 cm removed from the Rubber tule relieve. Use your feeling to make sure that the power lead does not roll-up in the compartment.
- Page 8 Step 4: Use the P-clip and the small cross head screw to attach the elastic band leading from the climate control unit to the Cabinaid lid. Please use the image below to see the allocated point where the screw needs to be placed. The right side picture shows how it should look when the elastic band is attached to the lid.
- Page 9 The AED hanging bracket is supplied as standard in your Cabinaid AED Cabinet. The following instruction will help you optimally install the hanging bracket. Step 1: Open the Cabinaid AED cabinet by pulling the handle and removing the lid from the storage compartment. The hanging bracket is already attached to the indicated location using 2x hexagon cap screws.
- Page 10 Step 3: Use a drill to drill a hole into the handle of the Cabinaid lid. It is best to drill from the back through the handle at the indicated location. See the image below for the location of the hole.
- Page 11 Cabinaid is a brand of AED Cup bv Celsiusstraat 15 • 6003 DG Weert • The Netherlands T. +31 (0)495 760156 • info@cabinaid.com • www.cabinaid.com...