Page 3
Two SDI input port switching with One HDMI out supported. HD-3000v2 supports Path A (HD-SDI input from J1 port convert to output HDMI at HDMI1/HDMI1A port) or Path B (HD-SDI input from J2 port convert to output HDMI at HDMI1/HDMI1A port). See Figure below : f.
On board tact switch to toggle from one SDI input to another one SDI input: * Tact switch functionality will be disabled when connected with a Digital View LCD controller as in (c) below. b) RS-232 commands (Refer to Appendix I) c) Connect with Digital View LCD controller (Refer to Appendix II) The last selected SDI input source will be memorized after power cycle.
Need help?
Do you have a question about the HD-3000v2 and is the answer not in the manual?
Questions and answers