VooDooFX CLK-1 Quick Start Manual
  1. Manuals
  2. Brands
  3. VooDooFX Manuals
  4. Toy
  5. CLK-1
  6. Quick start manual

VooDooFX CLK-1 Quick Start Manual

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

3312 Hoover St, Redwood City, CA 94063
650-568-3400
www.voodoofx.com
CLK-1
General Starting Instructions:
(1) Unpack lighting kit and parts.
(2) Read instructions & study circuit board diagram.
(3) Locate areas for circuit board, leds and battery.
(4) Locate mounting area for on/off switch.
(5) Prefabricate electronics as necessary.
(6) Study model kit & building instructions.
(7) Drill out locations for leds & wire chase ways.
(8) Test all lighting before install and after.
(9) Use a new 9 volt battery to test circuit board.
(10) Never test a led direct with a 9volt battery.
Over All Lighting Layout
Head Lights
Main Passenger Light
Robot Light
General Led Diagram
Battery & Switch Locations
On/Off Switch
9 Volt Battery
9 Volt Battery Location
Switch Location
Circuit Board Location
Led Locations
TUB Area

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLK-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for VooDooFX CLK-1

  • Page 1 3312 Hoover St, Redwood City, CA 94063 General Led Diagram 650-568-3400 www.voodoofx.com CLK-1 General Starting Instructions: Battery & Switch Locations (1) Unpack lighting kit and parts. (2) Read instructions & study circuit board diagram. (3) Locate areas for circuit board, leds and battery.
  • Page 2 (Circuit Board Diagram) (How to Make a Wired Led) 1- Separate the two wires. Pick what color will be positive+ and what color will be negative-. (Example) Lighter color is positive+, darker color is negative-. This will apply to any color, you make the choice. 2- Slide on two pieces of shrink tubing 1/8 - ¼...
  • Page 3 PHOTO 2 PHOTO 3 PHOTO 4 PHOTO 5 5- Drilling out for robot base pad & bench area. The rear of the robot base stand needs to drilled out for running wire around the inside of the bench area. See photo 6. The bench ends will need drill outs on the ends to allow a chase for the wires to run through.
  • Page 4 Voodoofx LLC authorized representative has been advised of the possibility of such damages.If your use of the product results in the need for servicing, repair...

Table of Contents