Advertisement
Product assembly
1
A
C D
B
Unpack the product and remove all packaging. Be
careful not to scratch the surface of the product
whilst removing the wrapping.
D
A
Fit the bulb: type and wattage as indicated on the
B
fitting. The wattage must not be exceeded.
-Remove the metal shade ring (A) already
attached to the lamp holder section.
-Lower the shade glass (B) over base section (C)
C
-Insert the metal shade ring (A) into the plastic
shade ring tool (D) and reattach to the lamp
holder to secure the shade in place.
Take care not to over tighten as this may cause
damage to the fitting. If cross threading occurs,
undo and start again
Plug the table lamp into the wall socket and switch
on. Your lamp is now ready for use.
02
Advertisement
