Summary of Contents for HKS 32016-BT002
- Page 1 HKS Exhaust System User & Installation Manual <32016-BT002> <E65400-A40020-00> 〝20230126〟 Ver.No2-1.1A...
- Page 2 Confirm Before Installation Part Number : 32016-BT002 Name of Product : Hi-Power Application : Scion FR-S (2012～2016) TOYOTA 86 (2017～2021) SUBARU BRZ (2012～2020) ★ Please make sure that the kit has all the provided parts listed below. ★ Be careful when handling this product; avoid dropping or giving it excessive impact.
- Page 3 Part Number : 32016-BT002 Name of Product : Hi-Power Application : Scion FR-S (2012～2016) TOYOTA 86 (2017～2021) SUBARU BRZ (2012～2020) Stock Nut Stock Spring Stock Bolt Stock Gasket #1 Mid Pipe Ring Gasket (φ75) Bolt(M10) Stock Rubber Stay Flat Washer...
-
Page 4: Product Precautions
Thank you for purchasing HKS exhaust system. Please read this User & Installation Manual thoroughly before using this product so that you will understand and use product correctly. Please confirm that the contents are correct before installation on the vehicle. -
Page 5: Installation Precautions
・Be careful to maintain the proper clearance when installing a new exhaust system. Please be particularly careful when working near brakes, fuel line, drivetrain and electrical systems. ・If you find cracks and other deterioration in the rubber exhaust hangers, replace them with the vehicle manufacturer's new standard parts. - 4/8 - 32016-BT002... - Page 6 ・In some instances it may be necessary to cut the stock exhaust into two pieces to remove it. The stock exhaust was installed before the rear suspension was installed on the vehicle. The replacement HKS exhaust system will bolt directly on and does not require any modification ( to the vehicle or the exhaust system).
-
Page 7: Installation Procedure
flange of the main muffler. Put the flat washer onto the provided bolt and pass it through from the front side. Attach the provided flat washers, spring washers, and nut in this order from the opposite side for assembling temporally. - 6/8 - 32016-BT002... - Page 8 （3）Drive for a while, then inspect that there is no leaking of the exhaust air and abnormal sounds from the flange at each section. （4）If there are any problems found in the (1) to (3), install the product again from the beginning. - 7/8 - 32016-BT002...
- Page 9 NOTICE Make sure there is sufficient clearance between the silencer and vehicle’ s bum per. If the clearance is insufficient(25 m m), cut out the shaded area of the bumper as shown below. - 8/8 - 32016-BT002...
- Page 12 HKS Co., Ltd. 7181 Kitayama, Fujinomiya, Shizuoka 418-0192, JAPAN https://www.hks-power.co.jp/en/...
Need help?
Do you have a question about the 32016-BT002 and is the answer not in the manual?
Questions and answers