1. SAFETY INFORMATION 1.1 General Introduction 1.2 Medical Background 1.3 Indication for Use 1.4 Contraindications 1.5 Warnings, Cautions, and Adverse Reactions 2. DEVICE PRESENTATION 2.1 Illustration of the Device 2.2 Illustration of the Accessories 3.OPERATING INSTRUCTIONS 4.CLEANING AND CARE 4.1 Tips for Skin Care...
1.1 General Introduction Thank you very much for using our Nerve Muscle Stimulator. For you use this device safely, please read this user manual carefully before your first use. Please keep this user manual with your device for future reference.
EXPLANATION OF EMS Electrical Muscle Stimulation (EMS) is an internationally accepted and proven way of treating muscular injuries. It works by sending electronic pulses to the muscle needing treatment; this causes the muscle to exercise passively. This device has low frequency and in conjunction with the square wave pattern allows direct work on muscle groupings.
EMS: The device is designed to be used to stimulate healthy muscles in order to improve or facilitate muscle performance. IMPORTANT SAFETY INFORMATION Read instruction manual before operating. Be sure to comply with all “Contraindications”, Warnings”, “Cautions” and “Adverse reactions” in the manual.
1.5 Warnings, Cautions, and Adverse Reactions Warnings 1.Apply stimulation only to normal, intact, clean, healthy skin. 2.Do not apply stimulation when in the bath or shower. 3.Do not apply stimulation while sleeping. 4.Do not use this device during pregnancy unless directed by your physician.
Page 8
17.Portable RF communications equipment (including peripherals such as antenna cables and external antennas) should be used no closer than 30 cm (12 inches) to any part of the equipment including cables specified by the manufacturer. Otherwise, degradation of the performance of this equipment could result.
Page 9
Adverse Reactions 1. Potential allergic reactions due to the electrical stimulation or gel including skin irritation, redness, burning or hypersensitivity. If skin irritation occurs, discontinue use and consult your physician. 2. Discomfort occurs due to improper stimulation levels, reduce the stimulation intensity or turn the device off directly.
2. DEVICE PRESENTATION 2.1 Illustration of the Device 6. Channel A intensity adjustment and channel A selector 7. Channel B intensity adjustment and channel B selector support@maytoyo.com...
Page 11
TENS/EMS/Modes 01-16 TENS modes 17-28 EMS modes TEMS MODE Intended Use Intended Use MODE back waist abdomen thigh calf neck back waist support@maytoyo.com...
2.2 Illustration of the Accessories Features of the Device LCD display A/B dual output Adjustable timer up to 90 minutes - modes TENS & Rechargeable internal Li-on battery 40 level intensity settings Allows 2- 4 pads to be applied to the different targeted areas at the same...
3. Operating instructions 1. Connect the pads to the wire by snapping them on, then remove the protective film. Note: adding a few drops of water on the pads will increase their longevity. 2.Place pads where the massage sensations are desired. And plug into one of the ports on the device.
Page 14
9. Select mode: Short press the "M/F" to select different modes in TENS & EMS functions, long press "M/F" to switch from TENS & EMS funtions. NOTE: Intensity level defaults to zero when starting unit or when changing modes for your safety.
4. CLEANING AND CARE 4.1 Tips for Skin Care Follow these suggestions to avoid skin irritation, especially if you have sensitive skin: 1. Wash the area of skin you will be placing the electrodes on with soap. Rinse thoroughly and dry the area completely before and after placing electrodes.
TO REMOVE YOUR ELECTRODES: 1. Lift the corner of the electrode and gently remove it from the skin. 2. It may be helpful to improve repeated electrode application by spreading a few drops of cold water over the adhesive side and turn the surface up to air dry.
Page 17
5. Please clean the main machine frequently. Use a piece of soft dry cloth to wipe the dirt on the main machine. Don't wash with water or clean with the detergent, thinner, volatile oil, etc. that contains chemical substances.
5. Trouble Shooting If your device does not seem to be operating correctly, refer to the chart below to determine what may be wrong. Should none of these measures correct the problem, the device should be serviced. support@maytoyo.com...
Need help?
Do you have a question about the KRES1080 and is the answer not in the manual?
Questions and answers