PROLED L6OP6 Series Installation Manual

PROLED FLEX STRIP OPAL 360 / 360 2G
Characteristics:
•
SMD CHIP MONO (white, neutral white, warm white, super warm white).
•
Power supply 24 VDC.
•
Homogenous light. No single points visible.
•
Safety class IP54. Suitable for wet room.
•
Operating temperature range -10° C till +45° C.
•
CE compliant with applicable European directives.
Warning:
1. For indoor use only.
2. Please ensure that the packaging is disposed of in a safe environment.
3. We do recommend that a qualified electrician should be used to install the products.
4. Do not look at the lighted lamp directly.
Safety indices:
Be sure to have a qualified electrician complete installation. The customer is not entitled to claim for any
lights installed without observing European safety directives. The manufacturer is then discharged from
liability when damage is caused by improper use or installation. For indoor use only. Protection class IP54.
Preinstallation:
Please follow the sequence of installation step by step. Non-observance can lead to damage of the flex strip.
1. Switch off the electricity at the mains before commencing installation or lamp change and (if a fuse box is
installed) remove the appropriate circuit fuse to avoid accidental switching on of the mains supply.
2. Connect the flex strip to the power supply 24 VDC output (secondary side).
3. Connect connector (primary side) of power supply to mains (220-240VAC).
4. If a dimmer is used, than it must be placed between power supply and the flex strip.
Installation possibilites:
1. Please keep in mind, that following strain is not allowed:
DO NOT PRESS
2. Minimum bending diameter at FLEX STRIP OPAL 360 / 360 2G
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
L6OP6xx / L6OP6xx2G
DO NOT TWIST
www.proled.com
Montageanleitung / Installation manual
DO NOT STRETCH