Before Using Your Wine Cellar; Installation Of Your Wine Cellar; Recommended Temperatures For Chilling Wine - Koolatron WC18-DZ User Manual

INSTALLATION

BEFORE USING YOUR WINE CELLAR

• Remove the exterior and interior packing.
• Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR WINE CELLAR

• This appliance is designed for free standing installation. Allow 50 mm of space between
the unit's side and 100 mm between back and the wall.
• Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
• Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit not to
perform properly.
• Avoid locating the unit in moist areas.
• Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning about power and/or grounding should be directed toward
a certified electrician or an authorized products service center.
50mm
2 in
100mm
4 in
50mm
2 in
4
OPERATING INSTRUCTIONS
1. Insert the power plug into the power socket.
Make sure the power socket is 110-120V AC/60Hz.
temperature
control
upper zone
temperature
display
2. Set the desired cooling temperature by pressing the buttons
desired temperature. Each depression of the buttons will scroll through the available
temperature settings. Numbers will flash while setting. Solid numbers indicate the current
internal temperature in Celcius or Fahrenheit. Switch to your preference using the °C to
°F switch.
3. Allow the empty Wine Cellar to operate for approx. 3 hours. This will allow it to reach
the desired temperature.
4. Fill the wine cooler with your choice of wine bottles. Allow 24 hours of operation
before the bottles reach the desired temperature.
5. The right touch control button operates both the interior light and switches the temp.
display from Celcius to Fahrenheit. Touch once to turn the interior light on or off.
To switch between Celcius and Fahrenheit, hold button for 4 seconds.
The Wine Cellar should be placed where the ambient temperature is between 59°F to 77°F
(15°C to 25°C). If the ambient temperature is above or below this range, the performance
of the unit may be affected. For example, placing your unit in extreme cold or hot conditions
may cause interior temperatures to fluctuate.

RECOMMENDED TEMPERATURES FOR CHILLING WINE

Red Wines: 15-18°C (59-66°F)
White Wines 8-15°C (46-59°F)
The above temperatures may fluctuate depending on whether the interior light is ON or
OFF or the bottles are located on the upper/middle/lower section.
interior light switch / temperature
°C to °F switch control
lower zone
temperature
display
or to set your
5