Advertisement
4. MAINTENANCE
4.1. Check the pump casing, suction and delivery tubes regularly for leaks.
4.2. Keep the pump clean for easy detection of leaks.
4.3. Remove and clean the filter every 10 hours of operation or sooner if the transfer flow begins to decrease.
4.4. Dispose of environmentally hazardous parts in the proper manner.
ØA
ØB
22
22
5. PERFORMANCE DATA
CONDITION
DELIVERY
(l/min)
BY-PASS
0
MAX BACK
27
PRESSURE
MAX DELIVERY
40
Performance Data given is for the transfer of diesel fuel at 20°C. The conditions indicated are as follows:
5.1
By-Pass - The pump operates in this mode when the delivery is closed and the internal by-pass valve automatically opens.
The pressure indicated is constant regardless of the type of delivery systems. Note that the unit can only operate in this condition
for a maximum of 2 to 3 minutes.
5.2
Maximum Back Pressure - These values are given for the maximum back pressure allowed with the by-pass valve closed.
Higher back pressures will cause the by-pass valve to open and reduce delivery volume. The back pressure should not exceed the value
given during normal operation.
5.3
Maximum Delivery - These values indicate the lowest back pressure and greatest delivery volume possible at once.
Note that with a vacuum at the point of suction, the pump will not operate when the vacuum reaches 0.7 bar. A vent will be required
to operate further. the pressure and vacuum can be read on the pressure gauges located near the orifices of the pressure
and vacuum hoses.
Declaration of Conformity
Diesel/Fluid Transfer Pump
Models TP96 & TP9624
73.23/EEC
Low Voltage Directive (S.I. 1994/3260)
89/336/EEC
EMC Directive (S.I. 1992/2372 & Amendments)
93/68/EEC CE Marking Directive
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this equipment
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call us for a copy of our latest catalogue on 01284 757525 and leave your full name and address including your postcode.
01284 757500
C
D
160
100
BACK PRESSURE
(bar)
1.1
0.8
0.1
We, the sole importer into the UK, declare that the products listed below are in conformity with the following EEC standards and directives
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
E
F
80
135
SUCTION
(bar)
/
0.3
0.3
The construction files for these products are held by the Manufacturer and may be inspected
on request by contacting Jack Sealey Ltd.
Signed by Mark Sweetman
01284 703534
G
ØH
97
6
Model TP96
Pump power . . .12 Volts (22 Amps, 140 Watts).
Fuse . . . . . . . . .25 Amps.
Duty cycle . . . . .30 minutes
Model TP9624
Pump power . . .24 Volts (13 Amps, 160 Watts).
Fuse . . . . . . . . .15 Amps.
Duty cycle . . . . .30 minutes
1st July 1999
www.sealey.co.uk
9A>
sales@sealey.co.uk
email
I
L
78
52
TP96, TP9624 - 3 - 201103
Advertisement
