Advertisement
STEP 2:
Identify conductor to appropriate signal name per
pinout table. The signal names are also etched on the
DGBH15FT PCB for reference. Note: Due to the wide
variety of SVGA cable, there is no standard color code
for the conductors other than the coaxial Red, Green,
Blue. The only certain way to identify correct
conductor is to perform a continuity test.
STEP 3:
Insert coaxial center conductors and shields as
well as conductors into appropriate slots of
terminal board by signal name in accordance
with SVGA pinout table and etched signal
names on the PCB. Tighten screws to secure.
STEP 4:
Attach the completed assembly to
mounting surface.
©L-com, Inc. All rights reserved.
45 Beechwood Drive • N. Andover, MA 01845 • Web: www.L-com.com • E-mail: sales@L-com.com
L-com Global Connectivity | 50 High St., West Mill, 3rd floor, Suite #30 | North Andover, MA 01845 | USA
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com Logo are registered marks.
Toll Free Ordering and Technical Support: 1-800-343-1455
Tel: 800-343-1455 • Fax: 978-689-9484 or 978-685-6467
SVGA PINOUT TABLE
PIN
SIGNAL
1
RED
2
GREEN
3
BLUE
4
ID BIT 2
5
GROUND
6
RED SHIELD
7
GREEN SHIELD COAX SHLD
8
BLUE SHIELD
9
DDV +5V
10 SYNC RTN
11 ID BIT 0
12 ID BIT 1
13 HORZ SYNC
14 VER SYNC
15 ID BIT 3
16 SHELL
DGBH15FT-INS REV. 09/06
Visit our website at www.L-com.com
WIRE
COAX CC
COAX CC
COAX CC
TP 1
TP1
COAX SHLD
COAX SHLD
COND 1
TP 3/4
TP 2
TP 2
COND 2
TP 3
TP 4
DRAIN WIRE
Advertisement
