Advertisement
Quick Links
A
Agile
Bruksanvisning / Use Instructions ver 1.0
Keep this manual together with the product for future use.
Store it inside, behind the acoustic front panel.
Including components
1
Screenwall
Assembly
(1 pcs)
Alternative for mounting
Abstracta´s recommended
display screen.
2
8
Foot
assembly
(2 pcs)
3
Screw M8
(4 pcs)
4
Spring washer
(4 pcs)
5
Cap nut (4 pcs)
6
Pin screw
(4 pcs)
7
Washer 4 (pcs)
Cable tie (2 pcs)
9
Splitted tube
(1 pcs)
Care instructions
To maintain the color and apparance, the product
should be vacuum cleaned regularly with a soft nozzle.
:
Stain removal
dab or wipe gently with a damp cloth.
Abstracta technical support,
tel.+46472269600.
Page 1 of 6
Advertisement
Related Manuals for ABSTRACTA Agile
Summary of Contents for ABSTRACTA Agile
- Page 1 Washer 4 (pcs) Care instructions To maintain the color and apparance, the product should be vacuum cleaned regularly with a soft nozzle. Stain removal dab or wipe gently with a damp cloth. Abstracta technical support, tel.+46472269600. Page 1 of 6...
- Page 2 Agile Bruksanvisning / Use Instructions ver 1.0 Mounting the feet and lifting If possible leave the screen wall on it's pallet while mounting the feet. If not possible, lift it to a table or elevated supportive surface. Be at least 3 persons to perform the heavy lifts during this assembly! In some cases 4 persons is good.
- Page 3 Use the USB-C-connector inside Agile to connect to your permanent installed electronic equipment. If you are installing Abstracta´s recommended conference equipment that demands another kind of USB-C cable, please go through the chapter below.
- Page 4 DC power to VB1. USB-C to VB1 Bose VB1. (See Bose's Agile with recommended conference equipment HDMI to VB1 manual for mounting instruction.) Use middle Bruksanvisning / Use Instructions ver 1.0 holes for Attention! For mounting Bose VB1, use the four shortest...
- Page 5 Mounting Bose VB1 and recommended distances Measure out, drill (drillbit = 2,5 mm to 3,0 mm) and mount the wall bracket included with Get started! Bose VB1. Attention! Use the short screws in the separate package coming with the conference kit. •...
- Page 6 H. 61 mm = Depth of Agile's framing. A screen assembly may be 10 -15 mm thicker than this without decreasing the looks. A very thin display geometry may not look good, if the backside of the display is visible outside the framing.
- Page 7 Mark out four of the bracket holes to the mounting board with a pencil. the top frame of Abstracta Agile). Calculate "H2" and mark out in the same way for the bottom bracket. Use a sharp tipped tool to punch deeper center marks for easier screwing! = Your wanted gap! (Min.
- Page 8 Abstracta Agile Monitor Bracket Bruksanvisning / Use Instructions ver 1.0 4. Place your cables needed for the 5. Mount the wallbrackets with the screws into your marks. monitor/TV or other eqipment. • Remove the panel by grabbing behind panel top and •...
- Page 9 • Connect your cables. monitor and in the lower space. Put straight and hanging on both • See "Abstracta Agile" user instructions for further cable back the panel and panel top. brackets. Be two persons! instructions! Slide to center monitor!