Original instructions VARILEX 1802 HT ® English 2. Specified conditions of use The angle grinders are suitable for grinding, sanding, abrasive cutting-off operations and Table of contents wire brushing metal, concrete, stone and similar 1. EC-Declaration of conformity ....4 materials without the use of water.
Original instructions VARILEX 1802 HT ® • Threaded mounting of accessories must match the sanding spindle thread. For accessories 4. General safety information mounted by flanges, the arbour hole of the accessory must fit the locating diameter of the flange. Accessories that do not match the WARNING –...
Page 6
Original instructions VARILEX ® 1802 HT 5.3 Safety warnings specific for grinding and • Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the housing and excessive abrasive cutting-off operations: accumulation of powdered metal may cause electrical hazards.
Page 7
Original instructions VARILEX 1802 HT ® 5.7 Additional safety instructions: • When the cutting disc is binding or when WARNING – Always wear protective interrupting a cut for any reason, switch off goggles. the power tool and hold the power tool motionless until the disc comes to a complete •...
Original instructions VARILEX 1802 HT ® 5.10 Reducing dust exposure: 6. Product features Some of the dust created using this power tool may contain chemicals known to cause 6.1. Power tool VARILEX 1802 HT – see cancer, allergic reaction, respiratory disease, ®...
Original instructions VARILEX 1802 HT ® 7. Technical data Subject to change in accordance with technical High-energy, high-frequency interferences can progress. cause speed fluctuations. The fluctuations Measured values determined in conformity with disappear, however, as soon as the interference EN 60745. fades away.
Original instructions VARILEX® 1802 HT See page 3, figures C1, C2 and C3. Accessories • Push and hold the lever (C1-1). Place the safety cover (C2) in the position indicated. Only use original Eisenblätter accessories. • Release the lever and turn the safety cover until the lever engages.
Original instructions VARILEX® 1802 HT 10.3 Securing/releasing the clamping nut: 10. Attaching the tools, working notes Securing the clamping nut: The 2 sides of the clamping nut (D1-4) are different. Screw Prior to any conversion work: Pull the mains plug from the clamping nut onto the spindle (D1-2) as follows: the socket.
Original instructions VARILEX 1802 HT ® 11. Switching on and off 12. Troubleshooting Always guide the machine with both hands. The electronic signal indicator (A2-1) lights up and the load speed decreases. Switch on first, then guide the accessory There is too much load on the machine! towards the workpiece.
Repairs to power tools must only be carried out by qualified electricians! If the connection lead is damaged, it must be replaced by a special connection lead. Contact CS UNITEC if you have Eisenblätter power tools requiring repairs: CS. UNITEC Inc. 22 Harbor Ave...
Page 16
CS. UNITEC Inc. 1-800-700-5919 (US/CA) 22 Harbor Avenue Norwalk, CT 06850 USA +1 203-853-9522 (Intl) 4330 Center Street Deer Park, TX 77536 USA Fax: 2038539921 info@csunitec.com www.csunitec.com 1-800-700-5919 (US/CA) +1-203-853-9522 (Intl.) www.csunitec.com info@csunitec.com www.csunitec.com Made in Germany...