Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Central Aquatics Turbo-Twist 9w
-
Page 2: Parts Diagram
HOSE LOCK HOSE BARB ADAPTOR LOCKING Water pump MAIN BODY HOSE not included. TAPERED BARB O-RING OUTLET SPECIFICATIONS Turbo-Twist 9w Turbo-Twist 18w Turbo-Twist 36w Article UVC Lamp 9 watt 18 watt 36 watt Rated Voltage AC120V AC120V AC120V Rated Cycle... -
Page 3: Set Up And Positioning
The Turbo-Twist Ultraviolet Pond Sterilizers are easy to set up and operate. Please read all instructions in their entirety before installation. To accommodate your new sterilizer, you will need a pump with an appropriate flow rate for the size of your UV Pond Sterilizer to ensure adequate ultraviolet exposure of pond water with appropriate frequency. - Page 4 2. UVC Lamp installation THREADED CAP UVC LAMP Remove threaded cap, install UVC lamp into socket until lamp “clicks” into place. Handle lamp with a clean cloth. 3. Reassembly Make sure that the flat O-ring gasket is properly positioned inside the threaded cap (already installed in unit).
-
Page 5: Tubing Connection
5. Installing the Turbo-Twist ➀ Attach Turbo-Twist brackets with screws on a fixed surface. ➁ Snap the main body into the brackets indicated by a “click”. SNAP-IN SNAP-IN SNAP-IN 6. Tubing connection WATER FLOW OUTLET FROM PUMP Connect the tubing between the water flow outlet and the hose barb inlet. - Page 6 7. Start water flow Turn on water supply to the Turbo-Twist. Once proper water flow has been established, tilt the unit and let the air bubbles inside the tubing and the main body escape. Examine the unit and check for any leaks.
-
Page 7: Maintenance
Maintenance To ensure superior performance, the quartz sleeve should be cleaned periodically. Cleaning the quartz sleeve ➀ Disconnect UV Pond Sterilizer from outlet, turn off the pump and let water drain from Turbo-Twist. (Picture 1) (PICTURE 1) ➁ Unscrew locking ring screw and slide tab down to release. -
Page 8: Troubleshooting
➅ Reassemble the Turbo-Twist. SOCKET (PICTURE 3) Troubleshooting If troubleshooting steps do not work, please contact Central Aquatics Tech Support for additional help. PROBLEM SOLUTION • The plug is not connected to • Connect the plug to the the power supply. - Page 9 W A R N I N G Please read instructions in their entirety before using the UV Pond Sterilizer. Cut off the power and stop using Cut off the power immediately if water if the UV Pond Sterilizer was submersed enters into the quartz housing.