ARBICO Organics Gypsy Assembly Instructions

Gypsy Moth Trap Assembly Instructions
Your Gypsy Moth Trap Includes:
Trap Body & Trap Hood (Gypsy Moth
lures sold separately)
Assembly Requirements:
Stapler, Twine & Twist Tie, 1 Binder Clip
Pop out the paper inserts from
the eight entry ports of the trap
body and crease the body lines
several times.
Slide the hood (shiny side up) over the top of the
trap and down the body of the trap until the tabs
in the center of the hood are below the slits
located above the eight entry ports.
Now slide the hood back up the body of the
trap, so that the small tabs on the hood slide into
the slits on the trap body. Staple the tabs to the
inside of the trap body.
Staple the gypsy moth lure to a twist tie or twine.
The lure should hang down the center of the trap.
Attach the twist tie or twine to the center hole in
the top. Secure with staple.
Increase moth capture by adding an insect
trap adhesive such as Stiky Stuff Adhesive or
Tangle-Trap Sticky Coating to the inside of
the trap.
Port
Entries
Bottom of Trap
Open and invert the trap, then
fit the bottom together and
staple, as shown below, with
stapling pliers.
Staples
Trap Hood
On the trap hood, pop out the
4 filler squares. Crease center
tabs upwards. Crease solid
corner lines.
Lure
Slits Above
Port Entries
Solid
Creases
Tabs
Tabs Stapled
to Trap Body
1 of 2