SolarGrow Solar Hydro Quad Slim Quick Start Manual

Contents
• 1 x Reservoir
• 1 x Support Tray
• 4 x Pots
• 4 x Feeder Mats
• 1 x Nutrients
• 1 x Access Cover

Set up instructions

• Place reservoir on an even surface.
• Position solar panel in a sunny aspect but do not connect to pump yet.
• Place water pump into centre of the reservoir.
• Position support tray onto reservoir.
• Place the access cover over the open end of the reservoir.
• Attach delivery system to the water pump.
• Position pump cover into place to keep light out of the reservoir.
• Wet one of the feeder mats and insert through the hole in the bottom of
the pot until the pointed tip is just below the top of the pot.
• Now place the pot on the support tray feeding the feeder mat through
the hole in the support tray. Ensure the feeder mat is touching the
bottom of the reservoir.
• Repeat for all remaining pots.
• Fill the pots with the HydroCoco taking care to keep the feeder mat
upright and central.
• Firm down ensuring good contact between the mat and HydroCoco.
• Make a hole in the HydroCoco large enough for your plant. Add your
plant and gently firm the HydroCoco down around the plant.
• Place 2 drippers into each pot, pushing them in approximately halfway.
• Water in well using a watering can with a fine rose until the HydroCoco
is moist, but not saturated.
Solargrow, Unit B1A Towngate Works, Dark Lane, Mawdesley, Lancashire, L40 2QU
Solar Hydro Quad Slim
• 1 x Pump Cover
• 1 x HydroCoco
• 1 x Solar Panel
• 1 x Delivery System
• 1 x Solar Pump