DCA Z1G-FF-15 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. DCA Manuals
  4. Tools
  5. Z1G-FF-15
  6. Operating instructions manual

DCA Z1G-FF-15 Operating Instructions Manual

Percussion hammer
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

Read through carefully and understand these instructions
before use.
Edition 2 July, 2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Z1G-FF-15 and is the answer not in the manual?

Questions and answers

Summary of Contents for DCA Z1G-FF-15

  • Page 1 Read through carefully and understand these instructions before use. Edition 2 July, 2011...

  • Page 2: General Safety Rules

    Personal Safety GENERAL SAFETY RULES 9. Stay alert, watch what you are doing and use common sense when operating (For All Tools) a power tool. Do not use tool while tired or under the influence of drugs, WARNING! Read and understand all instructions. Failure to alcohol, or medication.

  • Page 3: Specifications

    20. Maintain tools with care. Keep cutting tools sharp and clean. Properly SPECIFICATIONS maintained tools with sharp cutting edges are less likely to bind and are easier to control. Rated Power Input 1240 W 21. Check for misalignment or binding of moving parts, breakage of parts, 1400 …/min Blows per Minute and any other condition that may affect the tools operation.

  • Page 4: Instructions For Operation

    2． ． ． ． 11. Do not touch the bit or parts close to the bit immediately after operation; they Switch Operation may be extremely hot and could burn your skin. CAUTION: Before plugging in the tool, always check to see that the trigger switch 12.

  • Page 5: Maintenance And Inspection

    4． ． ． ． Oil Feeding MAINTENANCE AND INSPECTION CAUTION: Prior to oil feeding, always disconnect the plug from the CAUTION: receptacle. Always be sure that the tool is switched off and unplugged before attempting to Since an oil chamber is built in this perform inspection or maintenance.
  • Page 6 EXPLAINATION OF GENERAL VIEW Baffle Plate Cover Seal Armature Assembly Pan Head Screw M4×10 Pan Head Tapping Screw ST4.8×63 28 Oil Cap Screw Cover Rubber Seal Stator Assembly Pan Head Tapping Screw Flat Washer Trigger Switch Ball Bearing Oil Felt Wave Washer Hex Socket Head Screw M5×12 Handle Set...
  • Page 7 EXPLAINATION OF GENERAL VIEW Guide Pin Gear Housing Hex Socket Head Screw M8×20 Carbon Brush Holder Metal Plate Carbon Brush Connecting Rod Brush Holder Cap Needle Bearing Rubber Washer Crank Shaft Brush Holder Cap Cover Woodruff Key Pan Head Screw M4×10 Hex Socket Head Screw M5×16 Fiber Washer Bearing Retainer...

Table of Contents