Aalberts Flamco Flamconnect GW-10 Installation And Operating Instructions

Flamconnect
GW-10
Installation and Operating instructions
ENG

Connect communication cable to the gateway

1.
If supplied put th powerplug into the socket.

Flextronic controller (S90002)

3a.
Connect RS485 cable to the left RS485 port of Flextronic
controller. In the right RS485 a resistor needs to be placed.
Make sure the RS485 communication setting is on 'Gateway'.

SPC controller (S90000)

3c.
Connect the bushing plug onto the controller. The power
supply on the serial must be enabled via the device menu.
4 3

Registration gateway

4.
Register the gateway on the Flamconnect portal. Please use
www.flamcogroup.com/register-gateway
QR-code. Or fill in the serial number in the portal and press on
'register device'. The gateway needs 5 minutes to set up the
connection.
2 1
or scan the
Mount the antenna on the 'cell' connection
2.
Fix the gateway near the device. Make sure the antenna is
not surrounded by lots of metal parts or casing as this might
interrupt the cellulair signal.

LogoTronic controller (SG0004)

3b.
Connect RS485 cable to the LogoTronic controller. Make sure
the RS485 communication setting is on 'HFC protocol'.

Dekimo controller (S9001)

3d.
Connect the bushing plug onto the controller.
flamcogroup.com/manuals