OE Elsafe ARC-H LD Installation

For surfaces 20-25mm use the in box magnetic alignment card and template.
For surfaces 25-50mm an electronic alignment guide is separately available, please inquire.
Centre loose magnet on resonator mat template
1
and align magnets (thicknesses 20 -25mm)
Adjust to ensure correct clearance and
3
mark screw holes
Place Resonator Pad where resonator pad
4
template markings indicate
Use resonator pad template for accuracy
ARC H LD
ARC H LD is designed for surfaces 20-50mm thick.
INSTALLATION
Move aligned templates to desired location.
2
Trace around surface template
Note the cable entry on the
template and ensure the cable
end on the charging module is
Cable Entry
at the same end.
Fit ARC H LD with tape (provided) or
5
screws. Ensure cable entry is the same
end as the template cable entry
Ph: 1300 ELSAFE | w w w.oeelsafe.com.au | sales@oeelsafe.com.au
Cable
Entry