Advertisement
®
REMOVING AND REINSTALLING THE RING BURR
The ring burr may be removed for cleaning or maintenance.
TO REMOVE:
1.
Grip the two grind adjustment tabs and ensure that the grind adjustment ring is rotated fully counterclockwise. Otherwise, the ring burr will
be locked into place.
2.
Using the two burr lifting tabs, lift the ring burr straight up and out of the grinder. Ensure that the hopper gasket is not lost in the process.
TO REINSTALL:
1.
Ensure that the cone burr is installed properly.
2.
Grip the two grind adjustment tabs and ensure that the grind adjustment ring is rotated fully counterclockwise.
3.
Align the red burr lifting tab with the red mark on the grind adjustment ring. The three tabs protruding from the sides of the ring burr should
also align with the three slots in the top of the grind adjustment ring.
4.
Press the ring burr down into place.
5.
Ensure the hopper gasket is properly installed on the ring burr, with the thicker side of the gasket sitting within the plastic rim on top of the
ring burr.
REMOVING AND REINSTALLING THE CONE BURR
The Encore ESP is equipped with a quick-release knob on top of the cone burr, allowing for easy removal of the cone burr for cleaning or burr replacement.
TO REMOVE:
1.
Twist the quick-release knob clockwise until
the knob.
2.
Lift the cone burr straight up and out of the grinder.
*If there is difficulty in removing the quick-release knob, we recommend using a thick cloth or a glove to hold the cone burr in place, as it will rotate freely,
but take care as it may be sharp. Pliers may also be used to get a better grip on the quick-release knob.
Note: There are several parts that sit below the cone burr that may also be removed for cleaning and maintenance, shown in order in the diagram on the
next page. If these parts are removed with the cone burr, keep them arranged in the order shown for reinstallation.
TO REINSTALL:
1.
If the parts below the cone burr were removed for cleaning, place them back on the drive shaft in the order shown in the diagram.
2.
When placing the cone burr back onto the metal drive shaft, make sure that the two protrusions on part
D
and the two divots on the bottom of the cone burr.
3.
Place the quick-release knob onto the threaded part on top of the metal drive shaft and twist the knob counter-clockwise to tighten. Tighten
until the cone burr starts to rotate when the knob is turned.
January 2023 (v1.0)
ENCORE ESP™ OPERATIONS MANUAL
removed.*
There will be a small washer underneath the quick-release knob. Remove along with
E
are able to fit into the holes on part
8
Advertisement
