U-Line H-2015 Quick Start Manual

π
H-2015
INDUSTRIAL
ILLUMINATED MAGNIFIER
1. Locate and remove clamp from packaging.
2. Use the screw mechanism to open the clamp to the
thickness of desired mounting surface.
3. Slide clamp onto desired
mounting surface and
use screw mechanism to
tighten. (See Figure 1)
NOTE: Clamp
must be tightened
completely before
attaching lamp.
4. Remove lamp from
packaging.
CAUTION! Use both hands to hold lamp arm
closed when removing from packaging. Open
arm slowly and carefully.
5. Lower stem of lamp into
the hole in the clamp.
(See Figure 2)
6. Insert plug into properly
rated 120V outlet.
PAGE 1 OF 2
1-800-295-5510
uline.com
INSTALLATION
Figure 1
Figure 2
7. Adjust magnifier
head to desired
position and tighten
adjustment knobs to
secure the position on
each axis.
(See Figure 3)
8. Remove magnifier cover and toggle the switch to
activate the light.
NOTE: When not in use, replace magnifier
cover to prevent fire hazard.
REPLACEMENT BULB (H-2017 – SOLD SEPARATELY)
1. Turn off and unplug H-2015 before replacing the bulb.
2. Remove lamp from table clamp and lay on a clean,
flat surface with the underside of the magnifier head
facing up.
3. Use a Phillips head
screwdriver to remove
the four screws on
the underside of the
magnifier head.
(See Figure 4)
Figure 3
Figure 4
0516 IH-2015