Smart Solar Prism Solar Motion Light Instructions

Prism Solar Motion Light

Introduction

This solar light works by using energy generated by the solar panel during the day to charge the internal
rechargeable battery which is used to power the light at night. When in 1 of the 3 on modes it will automatically
illuminate at night by using a light sensor and motion sensor. The number of times it can illuminate at night will
depend of which mode you have it set to and how much charge the battery received during the day.

Contents

Battery already installed inside light.

Position

The motion sensor has a detection field of 120 degrees wide and a range of 10-15 feet away so make sure to
take that into account when choosing a location.
Day: Install in a location where the solar panel
can receive the maximum amount of direct sun.
Light coming through trees, screens, or windows
is not considered direct.

Installation

You can mount the light in a variety of locations such
as a wall, deck, shed, fence, post, etc. After you find
a good place to install the light you can attach it using
the screws provided through the holes in the top of
the light. Based on the material, to you can use the
walll anchors if needed.
Smart Solar is a Smart Living Home & Garden brand. © 2021 V0
Solar Panel with Light Sensor
Motion Sensor
On/Off/Mode Button
customerservice@smartlivinghg.com
Night: Do not install near another light as it
may interfere with the light sensor and prevent
the light from working properly at night.
www.smartlivinghg.com
Screws x2
Anchors x2
#SmartLivingHG