Ebyte E22-230TXXS User Manual page 20

Chengdu Ebyte Electronic Technology Co.,Ltd
Read/Wr
05H REG2
ite
Read/Wr
06H REG3
ite
CRYPT_
07H Write
H
CRYPT_
08H Write
L
80H~ Read
PID
86H only
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd
Channel control（CH）
0-64 represents a total of 65 channels
7 Enable RSSI
1：Enable
0：Disable（default）
--------------------------------------
6， Fixed point transmission
1：Fixed point transmission mode
0 ： Transparent transmission mode
（default）
---------------------------------------
5 Enable reply
1：Enable repeater function
0：Disable repeater function
--------------------------------------
4 LBT enable byte (monitor before
transmission)
1：Enable
0：Disable（default）
--------------------------------------
3 WOR transceiver control
1：WOR transmitter
The module receiving and transmitting
functions are turned on, and a wake-up code is
added when transmitting data. Receiving is turned
on.
0：WOR receiver（default）
The module is unable to transmit data
and works in WOR monitoring mode. The
monitoring period is as follows (WOR cycle),
which can save a lot of power.
---------------------------------------
2，1，0，WOR cycle
000：500ms
001：1000ms
010：1500ms
011：2000ms（default）
100：2500ms
101：3000ms
110：3500ms
111：4000ms
Key high byte (default 0）
Key low byte (default 0)
Product information 7 bytes
E22-230TXXS User Manual
Frequency= 220.125 + CH *0.25M

When enabled, the module receives wireless data and

it will follow an RSSI strength byte after output via
the serial port TXD
.---------------------------------------
The module recognizes the first three bytes of the

serial data as: address high + address low + channel
and takes it as the wireless transmitting target.
---------------------------------------
After the reply function is enabled, if the target

address is not the module itself, the module will
forward it once.
In order to prevent data return-back, it is

recommended to use it in conjunction with the fixed
point mode. That is: the target address is different
from the source address.
----------------------------------------
When enabled, wireless data will be monitored before

it is transmitted, which can avoid interference to a
certain extent, but may cause data delay.
----------------------------------------
Valid for mode 1 only：

1. In the receiving mode of WOR, the module can

modify the delay time after wake-up, and the default
time is 0;
2. The receiving end needs to send the instruction C0

09 02 03 E8 in configuration mode (C0 is the write
command, 09 is the register starter address, 02 is the
length, 03 E8 is the set delay, the maximum FFFF is
65535ms, set to 0 to turn off the wake-up delay. )
3. Data can be sent within the delay

---------------------------------------------
Valid only for mode 1.

Period T = (1 + WOR) * 500ms, maximum 4000ms,

minimum 500ms
The longer the WOR monitoring interval period, the

lower the average power consumption, but the greater
the data delay
Both the transmitter and the receiver must be the

same (very important).
Write only, read returns 0

Used for user encryption to avoid intercepting

airborne wireless data by similar modules.
The module will internally use these two bytes as a

calculation factor to transform and encrypt the
over-the-air wireless signal.
Product information 7 bytes

5