Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AquaLogic AQL-P-4
- Page 1 Aqua Logic Aqua Logic Aqua Logic Aqua Logic Aqua Logic Automation and Chlorination (actuators, cell & remote display not included - order separately) Installation Manual for model AQL-P-4 LINE www.goldlinecontrols.com ON TROLS 888-921-7665...
- Page 2 IMPORTANT SAFETY INSTRUCTIONS When using this electrical equipment, basic safety precautions should always be followed, including the following: READ AND FOLLOW ALL INSTRUCTIONS • • WARNING: Disconnect all AC power during installation. • WARNING: Water in excess of 100 degrees Fahrenheit may be hazardous to your health.
-
Page 3: Table Of Contents
Table of Contents Introduction Before You Begin..............1 Installation Steps..............2 1. Preparing General Water Chemistry............. Pool/Spa Water Salt..................4 2. Mounting Aqua Logic Control Center........... 6 Equipment Temperature Sensors............Optional AQL-CL Chlorination Kit........6 Optional Remote Controls............ 6 Optional Valve Actuators............7 3. -
Page 4: Introduction Before You Begin
Introduction Before You Begin What’s Included Before attempting to install the Aqua Logic system, check that the following components have been included in the package: Aqua Logic Electronics Unit (3) Temperature sensors with 15 ft. (5m) cable, hose clamp What’s NOT Included Some of the additional items that you may need to complete an installation include: Circuit breakers None are included with control—see page 10 and inside of door for suitable breakers... -
Page 5: Installation Steps
Installation Steps Details on each installation step are presented on the following pages: 1. Prepare the pool water (page 3) General Water Chemistry Salt 2. Mounting the equipment (page 6) Aqua Logic main unit Remote display/keypad (optional) Temperature sensors Valve actuators (if applicable) 3. -
Page 6: Preparing General Water Chemistry
1. Preparing Pool/Spa Water General Water Chemistry Salt is required only if you are using the chlorinator features on the Aqua Logic Control. If you are NOT using the chlorinator, it is recommended that you follow all of the other chemistry recommendations be- sides salt. -
Page 7: Pool/Spa Water Salt
The pool’s chemistry must be balanced BEFORE activating the Aqua Logic’s optional chlorinator func- tion. NOTE: If the pool does not have new water, add metal remover and non-copper based algaecide to the pool, per manufacturer’s instructions. This ensures a quick, troublefree transfer to the Aqua Logic system. - Page 8 Pool Sizing Formula Liters Gallons (pool size in meters) (pool size in feet) Length x Width x Length x Width x Rectangular Average Depth x 7.5 Average Depth x 1000 Diameter x Diameter x Diameter x Diameter x Round Average Depth x 5.9 Average Depth x 785 Length x Width x Length x Width x...
-
Page 9: Mounting Aqua Logic Control Center
2. Mounting the Equipment Aqua Logic Control Center The Aqua Logic is contained in a raintight enclosure that is suitable for outdoor mounting. The control must be mounted a minimum of 5 ft. (2 meters) horizontal distance from the pool/spa (or more, if local codes require). -
Page 10: Optional Valve Actuators
never touch the unit). The display/keypad is designed to mount onto a standard electrical utility box (same box as a single light switch, ideal for new construction) or can be mounted directly onto any wall surface. When selecting a location, note that the wire to the Aqua Logic main unit must be less than 500’ long. Refer to the remote’s installation instructions as well as the steps below: 1.
Need help?
Do you have a question about the AQL-P-4 and is the answer not in the manual?
Questions and answers