Table of Contents
Advertisement
Optional HP integrated USB peripheral modules
Description
HP Retail Integrated 7-inch Customer Facing Display
HP Retail Integrated 2x20 Display
HP Retail Integrated Barcode Scanner
HP Retail Integrated Fingerprint Reader
HP Integrated Single-Head MSR
HP Retail Integrated Webcam
Only HP approved integrated USB peripheral modules will work with the RP2, such as the HP webcam,
fingerprint reader, MSR (single-head and dual head), 2 x 20 LCD (complex and non-complex) customer facing
display, 7" LCD customer facing display, and 2D imager scanner.
NOTE:
Do not install an HP webcam, 2 x 20 LCD (complex and non-complex) customer facing display, or a 7"
LCD customer facing display on the sides of the display head. These three peripheral modules must be
installed on top of the display head for proper video orientation.
NOTE:
Only install HP approved USB peripherals designed for these USB ports. The USB ports do not
support optical drives or hard drives.
The procedure for installing an HP integrated USB peripheral module is the same for all modules. To install
an HP USB peripheral module, follow the steps below.
1.
Turn off the computer properly through the operating system, then turn off any external devices.
2.
Disconnect the power cord from the power outlet.
CAUTION:
the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to
the internal components of the computer.
Regardless of the power-on state, voltage is always present on the system board as long as
Optional HP integrated USB peripheral modules
27
Advertisement
Table of Contents
