Coleman INSTASTART 3150 Instructions For Use Manual page 5

Pole support
■ Assemble pole
assembly by inter-
locking shock-corded
poles. This will make
one long pole.
■ Thread pole
assembly into bottom
collar. (Fig. 7)
Fig. 7
CAUTION
• The post assembly must be set up in a vertical
position for the propane torch to function
properly.
Base support
■ For models with
base, screw base
onto bottom collar.
(Fig. 9)
Fig. 9
■ Place torch on a flat
and stable surface.
(Fig. 11)
■ Mount stake securely
into ground.
■ Place pole assembly
into stake. (Fig. 8)
Fig. 8
■ For models with
globe, place globe
inside torch. (Fig. 10)
Fig. 10
Fig. 11
English-4
To Light
WARNING
If you smell gas:
1. Do not attempt to light appliance.
2. Extinguish any open flame.
3. Disconnect from fuel supply.
4. Call 1-800-835-3278.
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can accumu-
late in low places. If you smell gas, leave the
area immediately.
• Always attach or detach propane source out-
doors; never while torch is lighted, near flame,
pilot lights, other ignition sources or while
torch is hot to touch.
• Always light & use torch outdoors.
• This torch must not be exposed to flammable
vapors or liquids during lighting.
• This torch is very hot during use and can
ignite flammables too close to the torch. Keep
flammables at least 72 inches from the sides
and 72 inches from the top of the torch. Keep
gasoline and other flammable liquids and
vapors well away from torch.
INSTASTART™ Electronic Ignition
■ For models with a
plastic cap, remove
plastic cap from
torch. (Fig. 12)
Fig. 12
■ Turn fuel valve full on. The valve should click
and a spark should jump between the electrode
and the burner and ignite the flame. (Fig. 14)
NOTE: If torch does not light, repeat above step
after turning fuel valve completely off. If the
torch is wet due to rain, high humidity, etc., the
valve may not spark. Use match lighting
procedure.
■ For models with a
soft bag, remove soft
bag from torch.
(Fig. 13)
Fig. 13
Fig. 14