Fluke DATAPAQ Tracker XL2 User Manual page 53

Maximum Temperature
Enter a maximum permitted temperature. By default, the value will be
the maximum temperature entered for Datapaq Value calculations. (See also
'Process File', below.)
Probe Selection
Probe selections can be set separately for each of the SmartPaq analyses.
Click on probe numbers to exclude them from the SmartPaq calculations.
Click to add or remove probes as necessary to match your setup. (Insight
remembers your selections, so it not necessary to repeat this unless your setup
changes.)
If the Transducer Interface(s) used contain more probes than are shown in this
dialog, the additional probes will be included in the SmartPaq calculation.
Process File
If you have already setup a process file in Insight which contains the parameters
you require for Datapaq Value, Time at Temperature or Maximum/Minimum
Temperature, click Select Process to browse to the process file. The relevant
parameters from that process file will then be entered automatically in the
SmartPaq Setup dialog.
For details of process files as used within Insight, select 'Process Files: Oven,
Recipe, Product' in the online Help system (on Insight's menu bar, select Help >
Contents).
Multiple Runs
For multiple runs (p. 48), select whether the SmartPaq pass/fail calculation will
be carried out for all runs or for only the first run.
Installing the Logger in the Thermal
Barrier, and Starting the Logger
Ensure the thermal barrier has cooled sufficiently since its last use.
Before using a new barrier for the first time, or if you suspect a barrier has
absorbed moisture, you should run it once through your process without the
logger to remove the moisture; see p. 29.
For correct selection of a suitable barrier, see p. 33.
53
Running a Temperature Profile
OVEN TRACKER XL2