Advertisement
FER9500 SQUARE CRIMP & FER9501 HEX CRIMP
COMFORT CRIMP
IMPORTANT:
information in this manual before operating or servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
In the event the SHURE STAKE
1.0
1.1
1. Open handles fully.
2. Position ferrule into the tool.
3. Close handles slightly
to secure ferrule. Do not
deform ferrule.
4. Insert stripped wire into the
ferrule.
5. Close handles until the
SHURE STAKE
mechanism
®
cycle has been completed.
6. Open tool and remove
crimped ferrule and wire.
Figure 2
TA05264 B Page 1 of 2
COMPRESSION TOOL WITH SHURE STAKE
®
For Installing Ferrules 26-8 AWG & 0.14-10mm
Read and understand all of the instructions and safety
mechanism must be released, please see Figure 3.
®
INSTRUCTIONS FOR USE
Ferrule and Crimp Installation
1
Open
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
2
3
Ferrule
4
5
Stripped
Wire
WARNING
DO NOT CRIMP ON HOT
ENERGIZED WIRES. DISCONNECT
POWER BEFORE INSTALLATION.
MECHANISM
®
2
Figure 1
6
Open
Advertisement
Table of Contents
Related Manuals for ABB FER9500
Summary of Contents for ABB FER9500
- Page 1 WARNING DO NOT CRIMP ON HOT ENERGIZED WIRES. DISCONNECT POWER BEFORE INSTALLATION. FER9500 SQUARE CRIMP & FER9501 HEX CRIMP COMFORT CRIMP COMPRESSION TOOL WITH SHURE STAKE MECHANISM ® ® For Installing Ferrules 26-8 AWG & 0.14-10mm IMPORTANT: Read and understand all of the instructions and safety information in this manual before operating or servicing this tool.
- Page 2 NOTICE: If tool does not operate properly, do no attempt repair or adjustment. Call nearest ABB Installation Products Inc. sales office to arrange for repair service. Any change, modification or alteration of the tool or use by the customer in a manner other than as specified by ABB Installation Products Inc.
Need help?
Do you have a question about the FER9500 and is the answer not in the manual?
Questions and answers