C-RACER FE-YT7 Quick Start Manual

www.c-racer.com
CONTENTS
1. 2pcs Fairing Extender
2. 4pcs screws Μ5Χ15 (allen-oval-washer)
3. 4pcs washers 5Χ15 (plastic)
Remove the side transparent piece by removing the two screws (red arrows) as shown in the photo. After
unscrewing it, pull it forward to unbutton the back part.
You may store the screws and side parts in case you want to restore it to its original form in the future.
Remove the bottom of the protective film and at the point it where it has the holes.
Then place the new side part step by step. First put the back of the side of the part in place of the old plastic (as
demostrated in the photo). It must enter the notch of the previous parts.
INSTRUCTION
Model
ΥΑΜΑΗΑ Tenere 700/T7
Page 1/2
Product
Fairing Extender
1.
Code
FE-YT7