Advertisement
3
Auto programming/Configuration (Solution 3000)
A)
When the Multicom BMC-3G is first connected to
the Bosch Alarm panel bus and powered up, it will
attempt to program the settings required for correct
alarm communications (RSC password / Installer
code must match). This is done automatically using
the same method as a direct connection (DLA USB
Serial) and A Link.
4
Download Installation Guide for Steps 4-14
If you go to the Suretek website:
https://mailchi.mp/suretek/multicom_bmc3g_press-release
You can download the Installation Guide and a Product Brochure.
An installer would need:
▶ Suretek AlarmLINK APP: allows Arm/Disarm control by customers.
▶ Suretek TechTools APP: used to program the Multicom unit.
Multicom Customer Service: 1300 654 433 (+61 2 8787 9865)
Email:
contact@suretek.com.au
Web:
www.suretek.com.au
Scan the QR Codes below to download Setup Guides and Apps
AlarmLINK Setup Guide
Setup the end user app for your
customer.
bit.ly/alinkguide
TechTools Download
Download the TechTools App for
smart phones.
bit.ly/multicom
B)
If auto programming fails due to
mismatch RSC password/installer code.
Then you can re-initiate auto-programming
by removing the Add jumper, wait 5
seconds, then replace.
!
For correct operation of the entire
system the RSC password (722) and
Installer Code (21) must be programmed
via TechTools to allow the Multicom
access to the 3000-series SDI-2 Bus.
Suretek website
(Shortcut)
AlarmLINK App Download
Available for iPhone and Android.
bit.ly/alinkapp
Multicom Full Manual
A complete instructional guide.
bit.ly/mc3gman
Advertisement
