Advertisement
Quick Links
Installing the
SVL-4 RMP, SVL-4A/B RMP, SVL-6 RMP
Step 1
CAUTION! Before removing top
cover disconnect the speaker selector
to the amplifier/receiver.
A: Remove the screws from the top
and sides of the chassis
B: Remove the top cover
Step 2
C: Turn each knob completely counter-
clockwise (to the full "off" position).
With a 5/64" allen wrench, locate the
two set screws on the side of the knob
and loosen both screws until the knob
can be removed. Remove all knobs
D: Remove the screws from the bottom of
the front panel and detach from the
chassis
Step 3
E: Secure the rack mount panel to
the chassis replacing screws at the
bottom of the panel
F: Return all of the knobs to the full
"off" position, secure both set
screws using the allen wrench
Step 4
G: Return the top cover to the unit
H: Replace the top cover screws
Niles Audio Corporation
© 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the
right to change product specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in
the USA 7/96 DS00176A
A
A
H
H
12331 S.W. 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185
www.nilesaudio.com
A
A
B
C
D
D
F
E
E
H
H
G
A
A
D
D
E
E
H
H
Advertisement
