Tp-Link HS200 Smart Wi-Fi Dimmer Switch Quick Start Guide

Also See for HS200:

User manual (36 pages)

Quick start manual (33 pages)

User manual (31 pages)

Table of Contents

Contents

1 Product Introduction
2 Wire Your Switch
3 Set Up Your Switch
- 3.1 STEP 1: DOWNLOAD APP
- 3.2 STEP 2: SET UP
4 Button Explanations
5 LED Status
6 Specifications
7 Safety Notice
8 Need some help?
9 Documents / Resources
- 9.1 References
- 9.2 Download manual

Tp-Link HS200 Smart Wi-Fi Dimmer Switch Quick Start Guide

Product Introduction

Built-in motion and ambient light sensors work together to realize hands-free control. Kasa smart dimmer switch turns on and dims the lights automatically, saving you effort and electricity bills.
Product Introduction

Ambient Light Sensor
Reset
Dimmer Buttons
Motion Sensor
On/Off Button
LED
Restart

Wire Your Switch

Turn off the circuit breaker and remove the old wallplate. Then label the wires.
Ground: Usually green or copper.
Neutral: Usually white and not connected to a dumb switch.
Line: Usually black and coming from the circuit breaker.
Load: Usually black. One end is connected to the light. If you are unsure, consult a qualified electrician.
Disconnect the wires.
Connect the wires to the smart dimmer switch as shown below.

Ground
Load
Line
Neutral

Secure the dimmer switch with screws.

Set Up Your Switch

STEP 1: DOWNLOAD APP

Get the Kasa Smart app from the Apple App Store or Google Play.

STEP 2: SET UP

Tap the button in the app and select Smart Switches. Then follow the step-by-step app instructions to set up your smart dimmer switch.
SET UP

Button Explanations

	Decrease or increase the brightness.
Reset	Press and hold for about 5s to reset your switch with configuration saved. Press and hold for about 10s to restore your switch to factory default settings.
Restart	Press to restart your switch.

LED Status

Flashing red	Starting up.
Flashing amber & green	Ready for setup.
Solid amber	Your phone is connected to the switch.
Flashing green	Connecting to Wi-Fi.
Stay green for 30s	Connected to Wi-Fi.
Solid red	Disconnected from Wi-Fi.
Flashing amber	The switch is being reset to factory default settings.
White	Light fixture is off.
Breathing white	The switch will be auto off.

Specifications

Rating: 120V~ 60Hz

Load: 300W Incandescent, 150W LED

Operation temperature: 0~40℃

Safety Notice

Before installing, servicing or removing the switch, read and follow all safety precautions including the following:

Risk of Electric Shock
More than one disconnect switch may be required to de-energize the equipment before servicing. A circuit breaker which disconnects the Line and Neutral conductor simultaneously is suitable. Ensure power is off at the circuit breaker before removing or installing any switch. Use a non-contact voltage tester to ensure the power is off.
The Smart Switch must be installed and used in accordance with the National Electric Code (NEC) or your local electrical code. If you are unfamiliar with these codes and requirements, or are uncomfortable performing the installation, consult a qualified electrician.
Do not install the Smart Switch with wet hands or when standing on wet or damp surfaces.
Install only in a suitable UL Listed outlet box (suitable dimensions: H > 2.95 in./75 mm, W > 1.81 in./46 mm, D > 2 in./51 mm).
Tighten terminal screws to 13 lbf-in.