Advertisement
This option reduces batteries consumtion when the Bluetooth connexion is not in use.
If Bluethooth mode is activated and it detects a mobile device within a 3 meters radius, the blue led will flash each 2 seconds. ( )
The App. Is only available for mobile devices such as IOS and ANDROID. And with a 4.0 Bluetooth technology.
The safe has the Master code already enabled by default:
Correct Code: Constant green light and beeping.
Incorrect Code: Constant red light and long beep.
Only possible with open door.
Correct Code: 3 times green light flashing and 3 beeps.
Incorrect Code: Constant red Light and long beep.
The safe has a high luminescence light which will be directed into it ( ),so that at the end of the opening process and while pressing the key, it will illuminate for 10 seconds. Activated by default.
The safe has a speaker which is activated by default.
Entering 4 consecutives incorrect codes, the system penalizes during 5 minutes (red light each 10 seconds). During this period, if someone presses any key, it sounds a long beep.
After 10 minutes without having introduced any code, the counter of wrong codes will reset to 0
The battery life is approximately 2 years. When the battery level is under its voltage, while pressing the key ,the red light is switched on and a discontinuous and long beep is heard. Open the safe to replace battery, following the previous instructions, and find the battery box on the back of the door.
Turn the lid screw of the battery box with the help of a coin and proceed with the battery replacement. Insert the batteries according to the position indicated as shown in the holder. Use always 1.5 Volt ALKALIN batteries, type LR6-AA. ( )
In case of total discharge of the battery, or any fault produced in the electronic system, you can proceed to the safe opening by using the S.O.S. key.
In the event of not changing the battery when they are worn-out and not having the S.O.S. key, the keyboard provides an electrical outlet to connect a 9V battery type 6F22 and thus to feed the system from the outside.( )
(only with the Master Code)
Important: User 9 allows an immediate opening evenin the delayed opening period.
Correct Code: Constant green light and beeping.
Incorrect Code: Constant red light and long beep.
(only with the Master Code)
(only with the Master Code)
A 1 to 99 minutes delayed time and a 1 to 19 minutes open window.
Valid operation: 3 times green light flashing and 3 beeps.
Invalid operation: Steady red light and long beep.
To modify the delayed time and the open window or to delete the opening delay, it can only be done when being into the opening time period.
To delete the opening delay, insert the delay value and the opening time value .
For instance:
Delay time: 10 minutes
Open window: 5 minutes
Correct Code: Constant green light and beeping.
Incorrect Code: Constant red light and long beep.
For instance:
User1:
Delay time: 10 minutes
Open window: 5 minutes
Correct Code: Constant green light and beeping.
Incorrect Code: Constant red light and long beep.
This code is automatically generated when the Master code and user codes are scheduled. It corresponds to the next number, immediately higher.
Exemples:
At the time when the duress code is typed, a signal to the interface alarm ( ) (optional) is immediately made and this last, at the same time is giving a NC/NA signal to the alarm control unit connected to the safe. This signal is programmed in the control unitas a Duress Emergency Report.
With that option, the initial settings return to the safe, meaning that:
Master Code: .
Users: Deactivated.
Delayed opening: 00 minutes.
Opening time: 00 minutes.
Time lock: Deactivated.
Inside light: Activated.
Buzzer: Activated.
Bluetooth mode: Deactivated.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download ARCAS OLLE 600, 800, 1000 Series -Key lock and electronic combination Using Instructions
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the 600 Series that isn't answered in the manual? Leave your question here.