CORSAIR iCUE NEXUS - Companion Touch Screen User Guide

HARDWARE SETUP

iCUE NEXUS connects to PC USB via the standalone base or when attached to a K70 RGB MK.2 or K95 RGB PLATINUM series keyboard via an included bracket.

STANDALONE BASE

1. Connect USB to base
2. Insert iCUE NEXUS
3. Connect base USB to PC

If attached to a keyboard, allow 24 hours for the adhesive tape on the bracket to set before using the touch screen. To remove the bracket later, turn over the keyboard and insert the included removal tool (H) into the gap between the bracket and the keyboard from the bottom side, and then gently press down to lift the bracket until it begins to detach. Hold the partially detached portion while continuing to lift different areas of the bracket until it is fully released from the keyboard. Additional brackets are available at www.corsair.com.

SOFTWARE SETUP

iCUE NEXUS requires the iCUE software. Download iCUE from www.corsair.com/downloads ; and install on your Windows^® PC.

• Launch iCUE, click the iCUE NEXUS device tile, and then go to the Screens tab to begin designing your own screens with custom graphics and functions.
• Swipe left and right on the touch screen to quickly navigate between screens.

NOTE: For more information on advanced programming and product tutorials, visit www.corsair.com/nexus-faq.

GETTING TO KNOW iCUE NEXUS

1. iCUE NEXUS
2. TOUCH SCREEN
3. USB CONNECTOR
4. STANDALONE BASE
5. BASE USB PASSTHROUGH
6. BASE USB CONNECTOR
7. KEYBOARD MOUNTING BRACKETS x 3
8. BRACKET REMOVAL TOOL

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

This device must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
CAN ICES-3(B)/NMB-3(B)

WEB: corsair.com
PHONE: (888) 222-4346
SUPPORT: support.corsair.com
BLOG: corsair.com/blog
FORUM: forum.corsair.com
YOUTUBE: youtube.com/corsairhowto