Eden David WT330 Manual page 8

Amp Outs – These consist of two _ inch jacks and an NL-4 connector
(sometimes called a Speakon). The jacks are wired in parallel. The total
speaker load impedance should not go below 2 ohms. On NL-4 connectors,
we use +1, -1 connections.
Amplifier Power Rating:
WT330
200 watts RMS @ 8 Ohms
330 watts RMS @ 4 Ohms
420 watts RMS @ 2 Ohms
WT390
235 watts RMS @ 8 Ohms
390 watts RMS @ 4 Ohms
625 watts RMS @ 2 Ohms
WT405
250 Watts RMS @ 8 Ohms
405 Watts RMS @ 4 Ohms
655 Watts RMS @ 2 Ohms
All models have +3dB of headroom. This means that the maximum output is
twice the RMS rating.
Mono Pre-Tone Effects Send/Return – These standard _ inch jacks allow
you to send and receive your signal to and from external devices. The effects
loop is positioned post (behind) the compressor and before the Enhance
control and the tone section. This loop is at line level; do not use instrument
level effects in this loop as they tend to be overloaded by the higher signal
level which can cause distortion.
Recording Out – This fully balanced XLR output allows you to send a pre-
or post-EQ signal to a recording or sound reinforcement mixing console. We
use Pin 2 hot configuration. Adjusting the Master Volume control will not
affect this send. This output is designed to use with phantom powered
systems. However, it never hurts to turn off the phantom power at the board,
if possible.
8