Advertisement
IMPORTANT: DO NOT OVER TIGHTEN THE SCREWS! OVER TIGHTENING THEM MAY MAKE THE GRILLE DIFFICULT TO INSTALL
7. Direct the tweeter. (CM630 only) The tweeter is directed by gently pressing on the outer edge of the tweeter housing. It will move up to
20 degrees in any direction. For critical listening, direct the tweeter towards the user's favorite listening position. For surround sound or
low volume background listening, create more reflections and thus more ambiance by directing the tweeter towards the sidewalls.
(See Figure 4)
8. Install grille desired. Each CM610 or CM630 loudspeaker includes both flush mount aluminum grilles and recessed cloth grilles that
masquerade as a light fixture. To install the MicroPerf™ grille, start by positioning one edge of the grille slightly inside the loudspeaker.
Gently work around the loudspeaker a little at a time until the grille is fully seated. Don't try to insert the grille fully in any one area, as
this will make complete installation more difficult. Don't force the grille to fit as you may damage the grille if you apply too much force.
9. To install the recessed light grille option, simply push the plastic grille evenly into the hole until it snaps in place.
10. Connect the other end of each loudspeaker wire to the receiver (or amplifier) carefully observing polarity.
11. Turn on the receiver or amplifier and test all loudspeakers in the system.
PAINTING THE GRILLE AND FRAME
Each CM610 or CM630 loudspeaker and flush-mount metal grille may be painted without the need for primer.
1. Install loudspeaker into ceiling or wall following the previous steps 1 - 6.
2. Remove the smallest perforated circle from the cardboard square template. This is the paint mask that protects the loudspeaker from
paint. Gently press it into place inside the baffle.
3. Paint the frame of the loudspeaker.
4. Paint the grille separately from the loudspeaker frame. For best results when painting the grille, use a spray gun or airless sprayer. Thin
the paint to prevent clogging of the grille holes and apply several light coats instead of one heavy one. Do not attempt to paint the plastic
and cloth grille.
5. Gently remove the paint mask after paint has dried by pressing in the tab in the center and carefully pulling out the mask with your
finger. Be very careful not to poke the tweeter with your finger.
6. Finish installation of the loudspeaker following the previous steps 7 –10.
Figure 1. Typical placement for stereo listening.
Figure 3. Mounting "dog" rotation.
Figure 2. New construction bracket.
Figure 4. Tweeter adjustment.
Advertisement
