Table of Contents
Advertisement
EN
Assembly Instructions
1. Remove the machine from carton and inspect for any visual damage.
2. Remove parts inside the machine.
3. Lay clan and hard card board on the floor and lay machine on its lid. (Make sure you hold cover closed when laying machine on its lid.)
4. Mount four legs on brackets with M6X12 phillips head screws and M6 nuts. NOTE: DO NOT TIGHTEN.
5. Place lower shelf between legs with flat surface up and atlach to legs with M6X12 phillips head screws and M6 nuts .
6. With legs press tight against lower shelf, tighten all screws to lower shelf.
7. Tighten all the screws installed in step 4.
8. Stand machine up, be careful to hold the lid closed.
9. Put work shelf and basket into the machine.
10. Mount pump assembly into slot on the side of the machine then place filter screen in position.
11. Plug machine into standard 115Volt 60Hz (240 Volt 50Hz) grounded outlet and fill with proper amount of fluid.
12. Turn switch on. Fluid should now be flowing from the flexible spigot.
Technical Data
SPECIFICATIONS
Overall Dimensions
Tank Dimensions
Max Solvent Capacity
Max Pump Output Through Spigot
Electrical Requirements
Gross Weight
Cleaning Solutions
Approved cleaning solutions:
Water/household deter{PH6-8)
Warning
The pump of your Parts Washer may be damaged if you use solvents other tha those llsted above such as methylethyl- ketonne(MEK), Perchloroethylene
or trichloroethylene.
Troubleshooting
The only trouble you should ever experience with your Parts Washer is reduced volume flow or no flow of cleaning liquid from the flex hose nozzle. The
probable cause is foreign matter In the flex hose.
Corrective Procedure
1.Check if the indicator light on switch box is lit
2.Using an insulated handle screw driver to lightly touch tip of housing of motor. A light oscillation magnatic pull indicates power is reaching to the motor.
3.Disconnect power plug, remove flex hose from pump flow-out line.
4.Remove front of pump housing by removlng 3 screws.Clean any foreign matter lodged around impeller.
5.Reassemble in reverse order.
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signif-
icantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury
or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.
2
Recirculating Parts Washer
79 x 53,7 x 88 cm
71 x 47 x 26 cm
80 lt
2.7 - 3.3 Liter/min
240V/50Hz
26 kg
WWW.NIKOLAOUTOOLS.GR
Advertisement
Table of Contents
