Advertisement
Quick Links
Taishan
Taishan
Low-temperature
Low-temperature
Steam & Distillation Still
Steam & Distillation Still
Best Tool for Flora-based Essential Oil & Hydrosols
Operation Manual
For any issues about the product, please contact us!
Customer service hotline: (06) 2688-500
Website: www.winemaker.com.tw
★ Please make use of the product with the product liability
insurance of NT$ 10 million confidentially!
★ This is a patented product, counterfeiting is not allowed.
80 l
Advertisement
Related Manuals for TaiShan 80l
Summary of Contents for TaiShan 80l
- Page 1 Taishan Taishan Low-temperature Low-temperature Steam & Distillation Still Steam & Distillation Still 80 l Best Tool for Flora-based Essential Oil & Hydrosols Operation Manual For any issues about the product, please contact us! Customer service hotline: (06) 2688-500 Website: www.winemaker.com.tw ★...
- Page 2 1-1. Outlet for collecting hydrosols: keep the lowest level for liquid outflows. Outlet for collecting 1-2. hydrosols Energy-saving Fill in water until the water sheath level is higher than the bottom of the pot. Hose for Sieve water supply layer Water valve (closed) Gas stove...
- Page 3 2-1. Tighten the stainless-steel tube by linking the water 2-2. valve and the automated water refill device. Install the overflow drain. Air valve (opened) Water valve (closed) Stainless-steel hose...
- Page 4 3-1. Fill in materials with a funnel. 3-3. Open the water valve; close the air valve when bubbles emerge from the air valve. 3-2. Place a gas stove. Check valve...
- Page 5 4-1. Remove the funnel and install a cooler. 4-2. 4-5. Connect the cooler and the cooling bucket with Connect it with stainless-steel hoses. a rubber hose 4-3. Air intake (used to keep an appropriate pressure inside the pot without vacuum) Connect the outlet for collecting hydrosols and the Coil pipe opening...
- Page 6 Cooler 5-2. Water emerges from the cooler and flows into Tap water Turn off tap 5-1. the automated from the water feeder. water when the cooling bucket to cooler is filled. the cooler Install an oil-water Air intake (used to keep an separator appropriate pressure inside the pot...
- Page 7 6-1. Air inside a hose is replaced by hydrosols and essential oil which are fed into the oil-water separator; connect an iron pipe 6-2. to the bucket in which hydrosols are collected. (It is recommended to keep Turn on tap the iron pipe at one position 2cm lower than the oil-water separator’s beak.) water slightly...