SII 99800088 Assembly Instructions

Cubetainer stackable tanks - gravity feed system

Table of Contents

Download this manual

Cubetainer Stackable Tanks - Gravity Feed System

Assembly Instructions

Screw threaded end of each pipe leg into couplers on the under-side of stand base.

2a.

Attach drip tray holder to front legs of stand. Leave ample space for your container below the drain

valve.

2b.

If the Cubetainer Gravity Feed System is ordered with containment tank #1032500N97801, then the

drip tray kit does not need to be used because the containment has a drip tray shelf pre-built in. In that

case the assembled stand (without drip tray kit) can be placed inside the containment and continue on

to step 4.

NOTE: If you have a 260 gallon Cubetainer it requires containment tank # 1007900N97801 and it does

not have a pre-built in drip tray shelf, so the drip tray kit should be installed on the stand and then

lowered into the containment, then proceed to step 4.

6940 O Street, Suite 100, Lincoln, NE 68510

P/N 99800088

Tools Needed:

• 1/2" wrench or crescent wrench

• 9/16" wrench or crescent wrench

• Utility knife

• Flat head screwdriver

• Channel lock pliers

Table of Contents

Do you have a question about the 99800088 and is the answer not in the manual?

Page 1 • Channel lock pliers Assembly Instructions P/N 99800088 Screw threaded end of each pipe leg into couplers on the under-side of stand base. Attach drip tray holder to front legs of stand. Leave ample space for your container below the drain valve.
Page 2 NOTE: Handle drip tray screens with care, outside edges are sharp. Snyder recommends wearing gloves when handling drip tray screens. Place drip tray insert pans w/ screen into the drip tray holder spaces. Attach elbow kit(s) to front lip of the stand base, using 1/2” wrench. Repeat as necessary. Stack all tanks vertically on stand.
Page 3 NOTE: Openings on drain port and elbow kits are 1” NPT. All threaded fittings must be coated with sufficient pipe thread sealant to prevent leakage. Snyder recommends Tru-Blu Thread Sealant with Teflon for all applications. Install valve directly into bottom tank drain port. Install additional valves into elbow kits on stand. Install poly elbow(s) into stacked tank drain port(s).
Page 4 Cut to length and attach clear poly tubing to barbed ends of the poly elbow(s) and poly union(s). Snyder recommends using a hose clamp on each end to secure each connection. Fill each tank. Be sure to double check each fitting for leaks. Snyder is not responsible for fluid loss or clean-up costs.