HomeSeer Technologies HST-IWAR7 Installation Manual

HomeSeer Technologies
7 " I n -
7 " I n -

Description/Specifications

In-Wall touch screen with Android operating system and HSTouch
 7" anti-glare resistive touch screen
 Android OS version 2.2
 800 MHZ ARM processor, 256MB RAM, 4GB Flash
 Ethernet connection on rear of unit
 POE (power of Ethernet) for power
 Auto starts when power is applied
 Auto starts HSTouch client application
 Front panel buttons for Back, volume, and Power
 Side loading micro SD card slot

Rear USB connection

System Requirements

 HomeSeer system version 2.5 or later with HSTouch Server installed, or any HomeSeer HomeTroller
 Ethernet Connection
 Power over Ethernet hub or injector that provides 48VDC

Installation

The screen can be mounted in a few different ways. It includes 4 spring clips that allow the screen to snap into the wall
opening. These clips may need to be adjusted depending on the thickness of the wall. Also, the clips can be removed and
the screen may be mounted directly to a piece of wood or metal that may be behind the opening in the wall.
WARNING: Be very careful when handling the clips as they have sharp edges. Never try to reposition the clips or bend
them with your fingers! Use pliers or other appropriate
The wall cut-out size should be 7.875"w x 5.50"h. Use the included template as your starting point. Once cut, you may
need to make this opening slightly larger to allow room for the spring clips. If you need to enlarge the opening, do so
gradually to ensure you don't end up with a hole too large. The minimal bezel width is ¼".
H o m e S e
H o m e S e
W a l l A n d r o i d
W a l l A n d r o i d
e r H S T -
e r H S T -
T o u c h S c r e e n
T o u c h S c r e e n
tools.
I W A R 7
I W A R 7
I n s t a l l a t i o n G
I n s t a l l a t i o n G
u i d e
u i d e