Adjustment, Replacement And Assembly Of Mechanical Units - Sharp VC-M522HM Quick Start Manual

4. ADJUSTMENT, REPLACEMENT AND ASSEMBLY OF MECHANICAL UNITS

The explanation given below relates to the on-site general service (field service) but it does not relates to the adjustment
and replacement which need high-grade equipment, jigs and skill. For example, the drum assembling, replacement and
adjustment service must be performed by the person who have finished the technical courses.
4-1 MECHANISM CONFIRMATION ADJUSTMENT JIG
So as to perform completely the mechanism adjustment prepare the following special jigs. So as to maintain the initial
performance of the machine the maintenance and check are necessary. Utmost care must be taken so that the tape is
not damaged. If adjustment needs any jig, be sure to use the required jig.
No. Jig ltem
1. Torque Cassette Meter
2. Torque Gauge
3. Torque Gauge Head
4. Torque Driver
Master Plane Jig and
Reel Disk Height
5.
Adjusting Jig
Tension Gauge
6.
Pinch pressing force
7.
measuring jig
Reverse guide height
9.
adjusting box driver
10. Alignment Tape
Guide roller height
11.
adjustment drive
X value adjustment
12.
gear type screw driver
Reverse Guide Height
13.
Adjusting Jig
Part No. Code
JiGVHT-063 CZ
JiGTG0090 CM
JiGTG1200 CN
JiGTH0006 AW
JiGTD1200 CB
JiGRH0002 BR
JiGMP0001 BY
JiGSG2000 BS
JiGSG0300 BF
JiGADP003 BK
JiGDRiVER11055 AR
VROUBZFS
CK
VROCPSV
JiGDRiVERH-4 AP
JiGDRiVER-6 BM
JiGRVGH-F18 BU
Configuration
This cassette torque meter is used for check-
ing and adjusting the torque of take-up for
measuring tape back tension.
These Jigs are used for checking
and adjusting the torque of take-up
and supply reel disks.
When fixing any part to the threaded
hole using resin with screw, use the
jig. (Specified torque 5 kg)
These Jigs are used for checking
and adjusting the reel disk height.
There are two gauges used for the
tension measurements, 300 g and
2.0kg.
This Jig is used with the tension
gauge. Rotary transformer clearance
adjusting jig.
This Jig is used for height adjustment of the
reverse guide (for reverse guide height ad-
justment).
625 Monoscope
625 Monoscope
This screwdriver is used for adjusting the
guide roller height.
For X value adjustment
This Jig is used for height
adjustment of the reverse guide.
9
VC-M522HM
VC-MH722HM
VC-MH732HM
Remarks
Video Audio Track
6kHz 35µm
6kHz
and and 49µm
Colour bar 1kHz