Advertisement
Quick Links
Advertisement
Summary of Contents for Haltech HT-038009
- Page 1 DCMD DC MOTOR DRIVER QUICK START GUIDE HT-038009...
-
Page 2: Product Overview
Elite or NEXUS device. will work in applications where the current NOTE: Native Turbosmart Electric Wastegate requirements are higher than the Haltech Elite control is limited to Elite and NEXUS series ECU’s stepper (1A) or DBW (3A) outputs can devices and is not supported on Platinum series provide. -
Page 3: Wiring Configuration
NSP SOFTWARE SETUP Calibration The calibration node is used to calibrate your Click “Calibrate” and NSP will perform the electronic wastegate. Make sure your engine is necessary adjustments automatically. turned off through this process. Don’t be alarmed if two messages pop up during To begin configuring your DCMD for use with Using NSP’s simple drop down menu, up to two Begin by clicking “Reset”, the status bar will... - Page 4 TURBOSMART EWG WIRING DIAGRAM (Motor A Control) (Motor B Control)
- Page 5 DTM connectors: sub-harness for an E-Gate installation. www.youtube.com/c/haltech 1. Crimp pin to wire. 2. Insert pin/wire into harness side of plug. 3. Insert wedge to lock pins in connector. DT Connector Diagram (Wire Side)
-
Page 6: Warranty Certificate
0% to the battery negative terminal or another work on your vehicle. Avoid sparks, open flames or use If the Haltech product is found to be defective as men- will request minimum flow through the turbo suitable ground source. - Page 7 Haltech Australia Haltech USA East Haltech UK 17 Durian Place, 750 Miles Point Way, Unit 1, Miras Business Estate, Wetherill Park NSW 2164 Lexington, KY 40510 USA Keys Park Road, Hednesford, Australia Phone: +1 888 298 8116 WS12 2FS Phone: +61 2 9729 0999 Email: usa@haltech.com...