Do you have a question about the LWB0301 and is the answer not in the manual?
Questions and answers
Summary of Contents for Landworks LWB0301
Page 1
Portable Winch Instruction Manual WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Save these instructions in a safe place and on hand so that they can be read when required. Keep these instructions to assist in future servicing.
CHARGER USE 1. Always fully charge battery before use. 2. Always use Landworks charger to charge Landworks type battery pack, Other types of batteries may burst causing damage and injury to person. 3. Never operate charger with damaged cord or plug. Replace them immediately.
Page 3
9. Never charge battery in damp or wet environment. 10. Always charge battery at temperatures between32°F-120°F (0°C-49°). 11. Always store battery at temperatures between 32°F-86°F (0°C-30°C). 12. Always disconnect charger when battery is fully charged. 13. Never probe with conductive object. 14.
PULLING SAFETY 1. Always keep pulling tool and pulling/lifting load in sight during pulling/lifting operation. 2. Always require operators and bystanders to be aware of rope and load. 3. Always be aware of stability of load during pulling lifting, keep others away. Alert all bystanders of any unstable condition.
READY FOR OPERATION To Charge the Battery for First Use 1. Connect the charger to standard 110 - 240 volt outlet; a red light should appear on the charger. NOTE: Always connect charger to standard 110 - 240 volt outlet before connecting battery.
7. DO NOT leave the charger being connected to the battery for more than 24 hours. 8. The battery status indicator is mounted on the top of the battery to allow you to observe the level of the battery power while in use. When all the 3 green lights and 1 red light are lit, it means the power is sufficient.
CAUTION Avoid Installing The Sling On Sharp Edges That Might Damage It. Whether You Are Using A Post, A Tree Or A Stump, Always Install The Sling Near The Anchor's Base. ROPE INSTALLATION The great variety of situations encountered when winching prevents us from providing specific instructions;...
2. Put the rope into the rope entry hook and under the drum (Figure 4, No. 1) 3. Wrap the rope around the drum (3 or 4 turns) (Figure 4, No. 2) 4. Bring the rope in the rope exit hook (Figure 4, No. 3) Fig.4 5.
WINCHING While winching, position yourself away from the winch in order to see both the winch and the load. Pull HORIZONTALLY on the rope. The tension you exert on the rope will keep the winch Cad Pull HORIZO level. DANGER do not wrap the rope around your handsor yur your body! alos beware of the rope accumulating in front of you;...
Page 11
EXPLODED AND PARTS LIST Part No. Description Q’ty Part No. Description Q’ty Power switch component The micro switch Screw st4.2x16f Casing Block Bearing 61805 Casing Transmission shaft Screw ST4.2x16F Block C 42 Plug assembly Aluminum shell Screw ST4.2x9.5F Limit block Motor assembly Screw M6X18 Screw M5x20...
Need help?
Do you have a question about the LWB0301 and is the answer not in the manual?
Questions and answers